Merge tag 'net-6.4-rc3' of git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net
Pull networking fixes from Paolo Abeni:
"Including fixes from can, xfrm, bluetooth and netfilter.
Current release - regressions:
- ipv6: fix RCU splat in ipv6_route_seq_show()
- wifi: iwlwifi: disable RFI feature
Previous releases - regressions:
- tcp: fix possible sk_priority leak in tcp_v4_send_reset()
- tipc: do not update mtu if msg_max is too small in mtu negotiation
- netfilter: fix null deref on element insertion
- devlink: change per-devlink netdev notifier to static one
- phylink: fix ksettings_set() ethtool call
- wifi: mac80211: fortify the spinlock against deadlock by interrupt
- wifi: brcmfmac: check for probe() id argument being NULL
- eth: ice:
- fix undersized tx_flags variable
- fix ice VF reset during iavf initialization
- eth: hns3: fix sending pfc frames after reset issue
Previous releases - always broken:
- xfrm: release all offloaded policy memory
- nsh: use correct mac_offset to unwind gso skb in nsh_gso_segment()
- vsock: avoid to close connected socket after the timeout
- dsa: rzn1-a5psw: enable management frames for CPU port
- eth: virtio_net: fix error unwinding of XDP initialization
- eth: tun: fix memory leak for detached NAPI queue.
Misc:
- MAINTAINERS: sctp: move Neil to CREDITS"
* tag 'net-6.4-rc3' of git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (107 commits)
MAINTAINERS: skip CCing netdev for Bluetooth patches
mdio_bus: unhide mdio_bus_init prototype
bridge: always declare tunnel functions
atm: hide unused procfs functions
net: isa: include net/Space.h
Revert "ARM: dts: stm32: add CAN support on stm32f746"
netfilter: nft_set_rbtree: fix null deref on element insertion
netfilter: nf_tables: fix nft_trans type confusion
netfilter: conntrack: define variables exp_nat_nla_policy and any_addr with CONFIG_NF_NAT
net: wwan: t7xx: Ensure init is completed before system sleep
net: selftests: Fix optstring
net: pcs: xpcs: fix C73 AN not getting enabled
net: wwan: iosm: fix NULL pointer dereference when removing device
vlan: fix a potential uninit-value in vlan_dev_hard_start_xmit()
mailmap: add entries for Nikolay Aleksandrov
igb: fix bit_shift to be in [1..8] range
net: dsa: mv88e6xxx: Fix mv88e6393x EPC write command offset
cassini: Fix a memory leak in the error handling path of cas_init_one()
tun: Fix memory leak for detached NAPI queue.
can: kvaser_pciefd: Disable interrupts in probe error path
...
[ upstream commit: 1f594fe7c90746982569bd4f3489e809104a9176 ]
diff --git a/Bindings/net/can/st,stm32-bxcan.yaml b/Bindings/net/can/st,stm32-bxcan.yaml
index 769fa5c..de1d429 100644
--- a/Bindings/net/can/st,stm32-bxcan.yaml
+++ b/Bindings/net/can/st,stm32-bxcan.yaml
@@ -21,11 +21,22 @@
st,can-primary:
description:
- Primary and secondary mode of the bxCAN peripheral is only relevant
- if the chip has two CAN peripherals. In that case they share some
- of the required logic.
+ Primary mode of the bxCAN peripheral is only relevant if the chip has
+ two CAN peripherals in dual CAN configuration. In that case they share
+ some of the required logic.
+ Not to be used if the peripheral is in single CAN configuration.
To avoid misunderstandings, it should be noted that ST documentation
- uses the terms master/slave instead of primary/secondary.
+ uses the terms master instead of primary.
+ type: boolean
+
+ st,can-secondary:
+ description:
+ Secondary mode of the bxCAN peripheral is only relevant if the chip
+ has two CAN peripherals in dual CAN configuration. In that case they
+ share some of the required logic.
+ Not to be used if the peripheral is in single CAN configuration.
+ To avoid misunderstandings, it should be noted that ST documentation
+ uses the terms slave instead of secondary.
type: boolean
reg:
diff --git a/src/arm/stm32f429.dtsi b/src/arm/stm32f429.dtsi
index c9e05e3..00bf53f 100644
--- a/src/arm/stm32f429.dtsi
+++ b/src/arm/stm32f429.dtsi
@@ -387,6 +387,7 @@
interrupt-names = "tx", "rx0", "rx1", "sce";
resets = <&rcc STM32F4_APB1_RESET(CAN2)>;
clocks = <&rcc 0 STM32F4_APB1_CLOCK(CAN2)>;
+ st,can-secondary;
st,gcan = <&gcan>;
status = "disabled";
};
diff --git a/src/arm/stm32f7-pinctrl.dtsi b/src/arm/stm32f7-pinctrl.dtsi
index c8e6c52..9f65403 100644
--- a/src/arm/stm32f7-pinctrl.dtsi
+++ b/src/arm/stm32f7-pinctrl.dtsi
@@ -283,6 +283,88 @@
slew-rate = <2>;
};
};
+
+ can1_pins_a: can1-0 {
+ pins1 {
+ pinmux = <STM32_PINMUX('A', 12, AF9)>; /* CAN1_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('A', 11, AF9)>; /* CAN1_RX */
+ bias-pull-up;
+ };
+ };
+
+ can1_pins_b: can1-1 {
+ pins1 {
+ pinmux = <STM32_PINMUX('B', 9, AF9)>; /* CAN1_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('B', 8, AF9)>; /* CAN1_RX */
+ bias-pull-up;
+ };
+ };
+
+ can1_pins_c: can1-2 {
+ pins1 {
+ pinmux = <STM32_PINMUX('D', 1, AF9)>; /* CAN1_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('D', 0, AF9)>; /* CAN1_RX */
+ bias-pull-up;
+
+ };
+ };
+
+ can1_pins_d: can1-3 {
+ pins1 {
+ pinmux = <STM32_PINMUX('H', 13, AF9)>; /* CAN1_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('H', 14, AF9)>; /* CAN1_RX */
+ bias-pull-up;
+
+ };
+ };
+
+ can2_pins_a: can2-0 {
+ pins1 {
+ pinmux = <STM32_PINMUX('B', 6, AF9)>; /* CAN2_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('B', 5, AF9)>; /* CAN2_RX */
+ bias-pull-up;
+ };
+ };
+
+ can2_pins_b: can2-1 {
+ pins1 {
+ pinmux = <STM32_PINMUX('B', 13, AF9)>; /* CAN2_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('B', 12, AF9)>; /* CAN2_RX */
+ bias-pull-up;
+ };
+ };
+
+ can3_pins_a: can3-0 {
+ pins1 {
+ pinmux = <STM32_PINMUX('A', 15, AF11)>; /* CAN3_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('A', 8, AF11)>; /* CAN3_RX */
+ bias-pull-up;
+ };
+ };
+
+ can3_pins_b: can3-1 {
+ pins1 {
+ pinmux = <STM32_PINMUX('B', 4, AF11)>; /* CAN3_TX */
+ };
+ pins2 {
+ pinmux = <STM32_PINMUX('B', 3, AF11)>; /* CAN3_RX */
+ bias-pull-up;
+ };
+ };
};
};
};
