| # RMT for NGW100 customization |
| |
| choice |
| prompt "RMT Version" |
| help |
| Select the RMTx board version. |
| |
| config BOARD_MRMT_REV1 |
| bool "RMT1" |
| config BOARD_MRMT_REV2 |
| bool "RMT2" |
| |
| endchoice |
| |
| config BOARD_MRMT_AC97 |
| bool "Enable AC97 CODEC" |
| help |
| Enable the UCB1400 AC97 CODEC driver. |
| |
| choice |
| prompt "Touchscreen Driver" |
| default BOARD_MRMT_ADS7846_TS |
| |
| config BOARD_MRMT_UCB1400_TS |
| bool "Use UCB1400 Touchscreen" |
| |
| config BOARD_MRMT_ADS7846_TS |
| bool "Use ADS7846 Touchscreen" |
| |
| endchoice |
| |
| choice |
| prompt "RMTx LCD Selection" |
| default BOARD_MRMT_LCD_DISABLE |
| |
| config BOARD_MRMT_LCD_DISABLE |
| bool "LCD Disabled" |
| |
| config BOARD_MRMT_LCD_LQ043T3DX0X |
| bool "Sharp LQ043T3DX0x or compatible" |
| help |
| If using RMT2, be sure to load the resistor pack selectors accordingly |
| |
| if BOARD_MRMT_REV2 |
| config BOARD_MRMT_LCD_KWH043GM08 |
| bool "Formike KWH043GM08 or compatible" |
| help |
| Be sure to load the RMT2 resistor pack selectors accordingly |
| endif |
| |
| endchoice |
| |
| if !BOARD_MRMT_LCD_DISABLE |
| config BOARD_MRMT_BL_PWM |
| bool "Use PWM control for LCD Backlight" |
| help |
| Use PWM driver for controlling LCD Backlight. |
| Otherwise, LCD Backlight is always on. |
| endif |
| |
| config BOARD_MRMT_RTC_I2C |
| bool "Use External RTC on I2C Bus" |
| help |
| RMT1 has an optional RTC device on the I2C bus. |
| It is a SII S35390A. Be sure to select the |
| matching RTC driver. |
| |
| choice |
| prompt "Wireless Module on ttyS2" |
| default BOARD_MRMT_WIRELESS_ZB |
| |
| config BOARD_MRMT_WIRELESS_ZB |
| bool "Use ZigBee/802.15.4 Module" |
| |
| config BOARD_MRMT_WIRELESS_BT |
| bool "Use Bluetooth (HCI) Module" |
| |
| config BOARD_MRMT_WIRELESS_NONE |
| bool "Not Installed" |
| endchoice |
