blob: 651d957d1051def00548673e5829ecbd302be7ec [file] [log] [blame]
* Samsung Exynos 5440 PCIe interface
This PCIe host controller is based on the Synopsys DesignWare PCIe IP
and thus inherits all the common properties defined in designware-pcie.txt.
Required properties:
- compatible: "samsung,exynos5440-pcie"
- reg: base addresses and lengths of the PCIe controller,
- reg-names : First name should be set to "elbi".
And use the "config" instead of getting the configuration address space
from "ranges".
NOTE: When using the "config" property, reg-names must be set.
- interrupts: A list of interrupt outputs for level interrupt,
pulse interrupt, special interrupt.
- phys: From PHY binding. Phandle for the generic PHY.
Refer to Documentation/devicetree/bindings/phy/samsung-phy.txt
For other common properties, refer to
Documentation/devicetree/bindings/pci/designware-pcie.txt
Example:
SoC-specific DT Entry (with using PHY framework):
pcie_phy0: pcie-phy@270000 {
...
reg = <0x270000 0x1000>, <0x271000 0x40>;
reg-names = "phy", "block";
...
};
pcie@290000 {
compatible = "samsung,exynos5440-pcie", "snps,dw-pcie";
reg = <0x290000 0x1000>, <0x40000000 0x1000>;
reg-names = "elbi", "config";
clocks = <&clock 28>, <&clock 27>;
clock-names = "pcie", "pcie_bus";
#address-cells = <3>;
#size-cells = <2>;
device_type = "pci";
phys = <&pcie_phy0>;
ranges = <0x81000000 0 0 0x60001000 0 0x00010000
0x82000000 0 0x60011000 0x60011000 0 0x1ffef000>;
#interrupt-cells = <1>;
interrupt-map-mask = <0 0 0 0>;
interrupt-map = <0 0 0 0 &gic GIC_SPI 21 IRQ_TYPE_LEVEL_HIGH>;
num-lanes = <4>;
};
Board-specific DT Entry:
pcie@290000 {
reset-gpio = <&pin_ctrl 5 0>;
};
pcie@2a0000 {
reset-gpio = <&pin_ctrl 22 0>;
};