blob: d57e9df25f4fa5e4c43b35862d318b7f9f6227ec [file] [log] [blame]
* Amlogic Meson SAR (Successive Approximation Register) A/D converter
Required properties:
- compatible: depending on the SoC this should be one of:
- "amlogic,meson8-saradc" for Meson8
- "amlogic,meson8b-saradc" for Meson8b
- "amlogic,meson8m2-saradc" for Meson8m2
- "amlogic,meson-gxbb-saradc" for GXBB
- "amlogic,meson-gxl-saradc" for GXL
- "amlogic,meson-gxm-saradc" for GXM
- "amlogic,meson-axg-saradc" for AXG
- "amlogic,meson-g12a-saradc" for AXG
along with the generic "amlogic,meson-saradc"
- reg: the physical base address and length of the registers
- interrupts: the interrupt indicating end of sampling
- clocks: phandle and clock identifier (see clock-names)
- clock-names: mandatory clocks:
- "clkin" for the reference clock (typically XTAL)
- "core" for the SAR ADC core clock
optional clocks:
- "adc_clk" for the ADC (sampling) clock
- "adc_sel" for the ADC (sampling) clock mux
- vref-supply: the regulator supply for the ADC reference voltage
- #io-channel-cells: must be 1, see ../iio-bindings.txt
Optional properties:
- amlogic,hhi-sysctrl: phandle to the syscon which contains the 5th bit
of the TSC (temperature sensor coefficient) on
Meson8b and Meson8m2 (which used to calibrate the
temperature sensor)
- nvmem-cells: phandle to the temperature_calib eFuse cells
- nvmem-cell-names: if present (to enable the temperature sensor
calibration) this must contain "temperature_calib"
saradc: adc@8680 {
compatible = "amlogic,meson-gxl-saradc", "amlogic,meson-saradc";
#io-channel-cells = <1>;
reg = <0x0 0x8680 0x0 0x34>;
interrupts = <GIC_SPI 73 IRQ_TYPE_EDGE_RISING>;
clocks = <&xtal>,
<&clkc CLKID_SAR_ADC>,
<&clkc CLKID_SANA>,
clock-names = "clkin", "core", "sana", "adc_clk", "adc_sel";