phy: for 4.15

 *) Add support in phy core to perform phy calibration
 *) Return NULL for optional PHY's even if CONFIG_GENERIC_PHY is not selected
 *) Add USB Phy driver for Broadcom STB SoCs
 *) Add support to force mediatek PHY with USB OTG function to enter
    a specific mode
 *) Calibrate rockchip-typec PHY according to docs
 *) Enable dual route feature for sun4i-usb in V3s SoC
 *) Use dr_mode dt property to enable otg capability in rcar-gen3-usb2
 *) Add driver data to specify dedicated otg pins in rcar-gen3-usb2 driver
 *) Configure the RX equalizer of brcm-sata PHY
 *) Update pcie phy settings for ti-pipe3 phy
 *) Add set_mode callback in qcom-ufs-qmp-14nm phy
 *) Use PHY callbacks in phy-qcom-ufs instead of export APIs
 *) Add callback to calibrate USB DRD PHY in exynos5420/5800

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
phy: exynos5-usbdrd: Calibrate LOS levels for exynos5420/5800

Adding phy calibration sequence for USB 3.0 DRD PHY present on
Exynos5420/5800 systems.
This calibration facilitates setting certain PHY parameters viz.
the Loss-of-Signal (LOS) Detector Threshold Level, as well as
Tx-Vboost-Level for Super-Speed operations.
Additionally we also set proper time to wait for RxDetect measurement,
for desired PHY reference clock, so as to solve issue with enumeration
of few USB 3.0 devices, like Samsung SUM-TSB16S 3.0 USB drive
on the controller.

We are using CR_port for this purpose to send required data
to override the LOS values.

On testing with USB 3.0 devices on USB 3.0 port present on
SMDK5420, and peach-pit boards should see following message:
usb 2-1: new SuperSpeed USB device number 2 using xhci-hcd

and without this patch, should see below shown message:
usb 1-1: new high-speed USB device number 2 using xhci-hcd

[Also removed unnecessary extra lines in the register macro definitions]

Signed-off-by: Vivek Gautam <gautam.vivek@samsung.com>
[adapted to use phy_calibrate as entry point]
Signed-off-by: Andrzej Pietrasiewicz <andrzej.p@samsung.com>

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
2 files changed