phy: sun4i-usb: Make sure to disable PHY0 passby for peripheral mode

On platforms where the MUSB and HCI controllers share PHY0, PHY passby
is required when using the HCI controller with the PHY, but it must be
disabled when the MUSB controller is used instead.

Without this, PHY0 passby is always enabled, which results in broken
peripheral mode on such platforms (e.g. H3/H5).

Fixes: ba4bdc9e1dc0 ("PHY: sunxi: Add driver for sunxi usb phy")

Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
diff --git a/drivers/phy/allwinner/phy-sun4i-usb.c b/drivers/phy/allwinner/phy-sun4i-usb.c
index 5163097..7b23920 100644
--- a/drivers/phy/allwinner/phy-sun4i-usb.c
+++ b/drivers/phy/allwinner/phy-sun4i-usb.c
@@ -551,6 +551,7 @@
 	struct sun4i_usb_phy_data *data =
 		container_of(work, struct sun4i_usb_phy_data, detect.work);
 	struct phy *phy0 = data->phys[0].phy;
+	struct sun4i_usb_phy *phy = phy_get_drvdata(phy0);
 	bool force_session_end, id_notify = false, vbus_notify = false;
 	int id_det, vbus_det;
 
@@ -607,6 +608,9 @@
 			mutex_unlock(&phy0->mutex);
 		}
 
+		/* Enable PHY0 passby for host mode only. */
+		sun4i_usb_phy_passby(phy, !id_det);
+
 		/* Re-route PHY0 if necessary */
 		if (data->cfg->phy0_dual_route)
 			sun4i_usb_phy0_reroute(data, id_det);