tree fb3b51113418753799430a937775bf1342a5cc84
parent 5d0c230f1de8c7515b6567d9afba1f196fb4e2f4
author Damien Le Moal <dlemoal@kernel.org> 1690172594 +0900
committer Damien Le Moal <dlemoal@kernel.org> 1690963272 +0900

ata,scsi: do not issue START STOP UNIT on resume

During system resume, ata_port_pm_resume() triggers ata EH to
1) Resume the controller
2) Reset and rescan the ports
3) Revalidate devices
This EH execution is started asynchronously from ata_port_pm_resume(),
which means that when sd_resume() is executed, none or only part of the
above processing may have been executed. However, sd_resume() issues a
START STOP UNIT to wake up the drive from sleep mode. This command is
translated to ATA with ata_scsi_start_stop_xlat() and issued to the
device. However, depending on the state of execution of the EH process
and revalidation triggerred by ata_port_pm_resume(), two things may
happen:
1) The START STOP UNIT fails if it is received before the controller has
   been reenabled at the beginning of the EH execution. This is visible
   with error messages like:

ata10.00: device reported invalid CHS sector 0
sd 9:0:0:0: [sdc] Start/Stop Unit failed: Result: hostbyte=DID_OK driverbyte=DRIVER_OK
sd 9:0:0:0: [sdc] Sense Key : Illegal Request [current]
sd 9:0:0:0: [sdc] Add. Sense: Unaligned write command
sd 9:0:0:0: PM: dpm_run_callback(): scsi_bus_resume+0x0/0x90 returns -5
sd 9:0:0:0: PM: failed to resume async: error -5

2) The START STOP UNIT command is received while the EH process is
   on-going, which mean that it is stopped and must wait for its
   completion, at which point the command is rather useless as the drive
   is already fully spun up already. This case results also in a
   significant delay in sd_resume() which is observable by users as
   the entire system resume completion is delayed.

Given that ATA devices will be woken up by libata activity on resume,
sd_resume() has no need to issue a START STOP UNIT command, which solves
the above mentioned problems. Do not issue this command by introducing
the new scsi_device flag no_start_on_resume and setting this flag to 1
in ata_scsi_dev_config(). sd_resume() is modified to issue a START STOP
UNIT command only if this flag is not set.

Reported-by: Paul Ausbeck <paula@soe.ucsc.edu>
Closes: https://bugzilla.kernel.org/show_bug.cgi?id=215880
Fixes: a19a93e4c6a9 ("scsi: core: pm: Rely on the device driver core for async power management")
Signed-off-by: Damien Le Moal <dlemoal@kernel.org>
Tested-by: Tanner Watkins <dalzot@gmail.com>
Tested-by: Paul Ausbeck <paula@soe.ucsc.edu>
Reviewed-by: Hannes Reinecke <hare@suse.de>
Reviewed-by: Bart Van Assche <bvanassche@acm.org>