gpio-lynxpoint: enable input sensing in resume
It appears that input sensing bit might be reset during
suspend/resume. Set input sensing again for all requested gpios
in resume
Tested-by: Jerome Blin <jerome.blin@intel.com>
Signed-off-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Acked-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/gpio-lynxpoint.c b/drivers/gpio/gpio-lynxpoint.c
index ff9eb911..fa945ec 100644
--- a/drivers/gpio/gpio-lynxpoint.c
+++ b/drivers/gpio/gpio-lynxpoint.c
@@ -407,9 +407,27 @@
return 0;
}
+static int lp_gpio_resume(struct device *dev)
+{
+ struct platform_device *pdev = to_platform_device(dev);
+ struct lp_gpio *lg = platform_get_drvdata(pdev);
+ unsigned long reg;
+ int i;
+
+ /* on some hardware suspend clears input sensing, re-enable it here */
+ for (i = 0; i < lg->chip.ngpio; i++) {
+ if (gpiochip_is_requested(&lg->chip, i) != NULL) {
+ reg = lp_gpio_reg(&lg->chip, i, LP_CONFIG2);
+ outl(inl(reg) & ~GPINDIS_BIT, reg);
+ }
+ }
+ return 0;
+}
+
static const struct dev_pm_ops lp_gpio_pm_ops = {
.runtime_suspend = lp_gpio_runtime_suspend,
.runtime_resume = lp_gpio_runtime_resume,
+ .resume = lp_gpio_resume,
};
static const struct acpi_device_id lynxpoint_gpio_acpi_match[] = {
