This removes all usage of global GPIO numbers from
arch/arm/mach-omap[12].
The patches have been reviewed and tested by everyone
who showed interest which was one person that tested
on OSK1 and Nokia 770, and we smoked out the bugs and
also addressed all review comments.
Any remaining problems can certainly be fixed in-tree.
ARM/musb: omap2: Remove global GPIO numbers from TUSB6010
The TUSB6010 (MUSB) device is picking up some GPIO lines
hardcoded by number and passing on to the TUSB6010 device
when registering it.
Instead of nasty workarounds, provide a GPIO descriptor
table and then make the TUSB6010 MUSB glue driver pick up
the GPIO lines directly, convert it to an IRQ and pass down
to the MUSB driver. OMAP2 is the only system using the
TUSB6010.
Stash the GPIO descriptors in the glue layer and use
then to power up and down the TUSB6010 on-demand, instead
of using boardfile callbacks.
Since the OMAP2 boards are the only boards using the
.set_power() and .board_set_power() callbacks, we can
just delete them as the power is now handled directly
in the TUSB6010 glue code.
Cc: Bin Liu <b-liu@ti.com>
Cc: linux-usb@vger.kernel.org
Fixes: 92bf78b33b0b ("gpio: omap: use dynamic allocation of base")
Acked-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
7 files changed
