Convert some wireless drivers to use GPIO descriptors
This converts some Wireless network drivers to use GPIO descriptors,
and some just have unused header inclusions.
The Intersil PL54 driver is intentionally untouched because Arnd
is cleaning it up fully.
To: Toke Høiland-Jørgensen <toke@toke.dk>
To: Kalle Valo <kvalo@kernel.org>
To: Arend van Spriel <aspriel@gmail.com>
To: Franky Lin <franky.lin@broadcom.com>
To: Hante Meuleman <hante.meuleman@broadcom.com>
To: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
To: Arnd Bergmann <arnd@arndb.de>
To: Lee Jones <lee@kernel.org>
To: Brian Norris <briannorris@chromium.org>
To: Srinivasan Raju <srini.raju@purelifi.com>
Cc: <linux-wireless@vger.kernel.org>
Cc: <linux-kernel@vger.kernel.org>
Cc: <brcm80211-dev-list.pdl@broadcom.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
---
Linus Walleij (6):
wifi: ath9k: Obtain system GPIOS from descriptors
wifi: ti: wlcore: sdio: Drop unused include
brcm80211: brcmsmac: Drop legacy header
wifi: mwifiex: Drop unused headers
wifi: plfxlc: Drop unused include
wifi: cw1200: Convert to GPIO descriptors
drivers/net/wireless/ath/ath9k/hw.c | 29 ++++-----
drivers/net/wireless/ath/ath9k/hw.h | 3 +-
.../net/wireless/broadcom/brcm80211/brcmsmac/led.c | 1 -
drivers/net/wireless/marvell/mwifiex/main.h | 2 -
drivers/net/wireless/purelifi/plfxlc/mac.c | 1 -
drivers/net/wireless/st/cw1200/cw1200_sdio.c | 42 +++++++------
drivers/net/wireless/st/cw1200/cw1200_spi.c | 71 ++++++++++++----------
drivers/net/wireless/ti/wlcore/sdio.c | 1 -
include/linux/platform_data/net-cw1200.h | 4 --
9 files changed, 82 insertions(+), 72 deletions(-)
---
base-commit: 6613476e225e090cc9aad49be7fa504e290dd33d
change-id: 20240122-descriptors-wireless-b8da95dcab35
Best regards,
wifi: cw1200: Convert to GPIO descriptors
The CW1200 uses two GPIOs to control the powerup and reset
pins, get these from GPIO descriptors instead of being passed
as platform data from boardfiles.
The RESET line will need to be marked as active low as we will
let gpiolib handle the polarity inversion.
The SDIO case is a bit special since the "card" need to be
powered up before it gets detected on the SDIO bus and
properly probed. Fix this by using board-specific GPIOs
assigned to device "NULL".
There are currently no in-tree users.
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
3 files changed
