Documentation/devicetree/bindings/media/sun6i-csi.txt

Allwinner V3s Camera Sensor Interface
-------------------------------------

Allwinner V3s SoC features a CSI module(CSI1) with parallel interface.

Required properties:
  - compatible: value must be one of:
    * "allwinner,sun6i-a31-csi"
    * "allwinner,sun8i-h3-csi", "allwinner,sun6i-a31-csi"
    * "allwinner,sun8i-v3s-csi"
  - reg: base address and size of the memory-mapped region.
  - interrupts: interrupt associated to this IP
  - clocks: phandles to the clocks feeding the CSI
    * bus: the CSI interface clock
    * mod: the CSI module clock
    * ram: the CSI DRAM clock
  - clock-names: the clock names mentioned above
  - resets: phandles to the reset line driving the CSI

The CSI node should contain one 'port' child node with one child 'endpoint'
node, according to the bindings defined in
Documentation/devicetree/bindings/media/video-interfaces.txt.

Endpoint node properties for CSI
---------------------------------
See the video-interfaces.txt for a detailed description of these properties.
- remote-endpoint	: (required) a phandle to the bus receiver's endpoint
			   node
- bus-width:		: (required) must be 8, 10, 12 or 16
- pclk-sample		: (optional) (default: sample on falling edge)
- hsync-active		: (required; parallel-only)
- vsync-active		: (required; parallel-only)

Example:

csi1: csi@1cb4000 {
	compatible = "allwinner,sun8i-v3s-csi";
	reg = <0x01cb4000 0x1000>;
	interrupts = <GIC_SPI 84 IRQ_TYPE_LEVEL_HIGH>;
	clocks = <&ccu CLK_BUS_CSI>,
		 <&ccu CLK_CSI1_SCLK>,
		 <&ccu CLK_DRAM_CSI>;
	clock-names = "bus", "mod", "ram";
	resets = <&ccu RST_BUS_CSI>;

	port {
		/* Parallel bus endpoint */
		csi1_ep: endpoint {
			remote-endpoint = <&adv7611_ep>;
			bus-width = <16>;

			/* If hsync-active/vsync-active are missing,
			   embedded BT.656 sync is used */
			hsync-active = <0>; /* Active low */
			vsync-active = <0>; /* Active low */
			pclk-sample = <1>;  /* Rising */
		};
	};
};