blob: 4139db353d0a9846bd88d0f442988a2d8a2f53b7 [file] [log] [blame]
Some socs have a large number of interrupts requests to service
the needs of its many peripherals and subsystems. All of the
interrupt lines from the subsystems are not needed at the same
time, so they have to be muxed to the irq-controller appropriately.
In such places a interrupt controllers are preceded by an CROSSBAR
that provides flexibility in muxing the device requests to the controller
Required properties:
- compatible : Should be "ti,irq-crossbar"
- reg: Base address and the size of the crossbar registers.
- ti,max-irqs: Total number of irqs available at the interrupt controller.
- ti,max-crossbar-sources: Maximum number of crossbar sources that can be routed.
- ti,reg-size: Size of a individual register in bytes. Every individual
register is assumed to be of same size. Valid sizes are 1, 2, 4.
- ti,irqs-reserved: List of the reserved irq lines that are not muxed using
crossbar. These interrupt lines are reserved in the soc,
so crossbar bar driver should not consider them as free
Optional properties:
- ti,irqs-skip: This is similar to "ti,irqs-reserved", but these are for
SOC-specific hard-wiring of those irqs which unexpectedly bypasses the
crossbar. These irqs have a crossbar register, but still cannot be used.
- ti,irqs-safe-map: integer which maps to a safe configuration to use
when the interrupt controller irq is unused (when not provided, default is 0)
crossbar_mpu: @4a020000 {
compatible = "ti,irq-crossbar";
reg = <0x4a002a48 0x130>;
ti,max-irqs = <160>;
ti,max-crossbar-sources = <400>;
ti,reg-size = <2>;
ti,irqs-reserved = <0 1 2 3 5 6 131 132 139 140>;
ti,irqs-skip = <10 133 139 140>;
See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt and
Documentation/devicetree/bindings/arm/gic.txt for further details.
An interrupt consumer on an SoC using crossbar will use:
interrupts = <GIC_SPI request_number interrupt_level>
When the request number is between 0 to that described by
"ti,max-crossbar-sources", it is assumed to be a crossbar mapping. If the
request_number is greater than "ti,max-crossbar-sources", then it is mapped as a
quirky hardware mapping direct to GIC.
device_x@0x4a023000 {
/* Crossbar 8 used */
interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>;
device_y@0x4a033000 {
/* Direct mapped GIC SPI 1 used */