| * STMicroelectronics STM32 USART |
| |
| Required properties: |
| - compatible: Can be either "st,stm32-usart", "st,stm32-uart", |
| "st,stm32f7-usart" or "st,stm32f7-uart" depending on whether |
| the device supports synchronous mode and is compatible with |
| stm32(f4) or stm32f7. |
| - reg: The address and length of the peripheral registers space |
| - interrupts: The interrupt line of the USART instance |
| - clocks: The input clock of the USART instance |
| |
| Optional properties: |
| - pinctrl: The reference on the pins configuration |
| - st,hw-flow-ctrl: bool flag to enable hardware flow control. |
| - dmas: phandle(s) to DMA controller node(s). Refer to stm32-dma.txt |
| - dma-names: "rx" and/or "tx" |
| |
| Examples: |
| usart4: serial@40004c00 { |
| compatible = "st,stm32-uart"; |
| reg = <0x40004c00 0x400>; |
| interrupts = <52>; |
| clocks = <&clk_pclk1>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_usart4>; |
| }; |
| |
| usart2: serial@40004400 { |
| compatible = "st,stm32-usart", "st,stm32-uart"; |
| reg = <0x40004400 0x400>; |
| interrupts = <38>; |
| clocks = <&clk_pclk1>; |
| st,hw-flow-ctrl; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&pinctrl_usart2 &pinctrl_usart2_rtscts>; |
| }; |
| |
| usart1: serial@40011000 { |
| compatible = "st,stm32-usart", "st,stm32-uart"; |
| reg = <0x40011000 0x400>; |
| interrupts = <37>; |
| clocks = <&rcc 0 164>; |
| dmas = <&dma2 2 4 0x414 0x0>, |
| <&dma2 7 4 0x414 0x0>; |
| dma-names = "rx", "tx"; |
| }; |
