| /* $Id: generic.c,v 1.17 2001/04/09 04:08:06 davem Exp $ |
| * generic.c: Generic Sparc mm routines that are not dependent upon |
| * MMU type but are Sparc specific. |
| * |
| * Copyright (C) 1996 David S. Miller (davem@caip.rutgers.edu) |
| */ |
| |
| #include <linux/kernel.h> |
| #include <linux/mm.h> |
| #include <linux/swap.h> |
| #include <linux/pagemap.h> |
| |
| #include <asm/pgalloc.h> |
| #include <asm/pgtable.h> |
| #include <asm/page.h> |
| |
| static inline void forget_pte(pte_t page) |
| { |
| if (pte_none(page)) |
| return; |
| if (pte_present(page)) { |
| struct page *ptpage = pte_page(page); |
| if ((!VALID_PAGE(ptpage)) || PageReserved(ptpage)) |
| return; |
| page_cache_release(ptpage); |
| return; |
| } |
| swap_free(pte_to_swp_entry(page)); |
| } |
| |
| /* Remap IO memory, the same way as remap_page_range(), but use |
| * the obio memory space. |
| * |
| * They use a pgprot that sets PAGE_IO and does not check the |
| * mem_map table as this is independent of normal memory. |
| * |
| * As a special hack if the lowest bit of offset is set the |
| * side-effect bit will be turned off. This is used as a |
| * performance improvement on FFB/AFB. -DaveM |
| */ |
| static inline void io_remap_pte_range(pte_t * pte, unsigned long address, unsigned long size, |
| unsigned long offset, pgprot_t prot, int space) |
| { |
| unsigned long end; |
| |
| address &= ~PMD_MASK; |
| end = address + size; |
| if (end > PMD_SIZE) |
| end = PMD_SIZE; |
| do { |
| pte_t oldpage; |
| pte_t entry; |
| unsigned long curend = address + PAGE_SIZE; |
| |
| entry = mk_pte_io((offset & ~(0x1UL)), prot, space); |
| if (!(address & 0xffff)) { |
| if (!(address & 0x3fffff) && !(offset & 0x3ffffe) && end >= address + 0x400000) { |
| entry = mk_pte_io((offset & ~(0x1UL)), |
| __pgprot(pgprot_val (prot) | _PAGE_SZ4MB), |
| space); |
| curend = address + 0x400000; |
| offset += 0x400000; |
| } else if (!(address & 0x7ffff) && !(offset & 0x7fffe) && end >= address + 0x80000) { |
| entry = mk_pte_io((offset & ~(0x1UL)), |
| __pgprot(pgprot_val (prot) | _PAGE_SZ512K), |
| space); |
| curend = address + 0x80000; |
| offset += 0x80000; |
| } else if (!(offset & 0xfffe) && end >= address + 0x10000) { |
| entry = mk_pte_io((offset & ~(0x1UL)), |
| __pgprot(pgprot_val (prot) | _PAGE_SZ64K), |
| space); |
| curend = address + 0x10000; |
| offset += 0x10000; |
| } else |
| offset += PAGE_SIZE; |
| } else |
| offset += PAGE_SIZE; |
| |
| if (offset & 0x1UL) |
| pte_val(entry) &= ~(_PAGE_E); |
| do { |
| oldpage = *pte; |
| pte_clear(pte); |
| set_pte(pte, entry); |
| forget_pte(oldpage); |
| address += PAGE_SIZE; |
| pte++; |
| } while (address < curend); |
| } while (address < end); |
| } |
| |
| static inline int io_remap_pmd_range(pmd_t * pmd, unsigned long address, unsigned long size, |
| unsigned long offset, pgprot_t prot, int space) |
| { |
| unsigned long end; |
| |
| address &= ~PGDIR_MASK; |
| end = address + size; |
| if (end > PGDIR_SIZE) |
| end = PGDIR_SIZE; |
| offset -= address; |
| do { |
| pte_t * pte = pte_alloc(current->mm, pmd, address); |
| if (!pte) |
| return -ENOMEM; |
| io_remap_pte_range(pte, address, end - address, address + offset, prot, space); |
| address = (address + PMD_SIZE) & PMD_MASK; |
| pmd++; |
| } while (address < end); |
| return 0; |
| } |
| |
| int io_remap_page_range(unsigned long from, unsigned long offset, unsigned long size, pgprot_t prot, int space) |
| { |
| int error = 0; |
| pgd_t * dir; |
| unsigned long beg = from; |
| unsigned long end = from + size; |
| struct mm_struct *mm = current->mm; |
| |
| prot = __pgprot(pg_iobits); |
| offset -= from; |
| dir = pgd_offset(mm, from); |
| flush_cache_range(mm, beg, end); |
| |
| spin_lock(&mm->page_table_lock); |
| while (from < end) { |
| pmd_t *pmd = pmd_alloc(current->mm, dir, from); |
| error = -ENOMEM; |
| if (!pmd) |
| break; |
| error = io_remap_pmd_range(pmd, from, end - from, offset + from, prot, space); |
| if (error) |
| break; |
| from = (from + PGDIR_SIZE) & PGDIR_MASK; |
| dir++; |
| } |
| spin_unlock(&mm->page_table_lock); |
| |
| flush_tlb_range(current->mm, beg, end); |
| return error; |
| } |