| This document specifies the AT command set used in the bluetooth ofono plugins. |
| |
| Bluetooth Dial-up Networking Profile Features Description |
| ========================================================= |
| (Ref. document: Dial-up Networking Profile - Bluetooth specification version 1.1 - 22 February 2001) |
| |
| - AT COMMAND SET USED: |
| Commands: |
| &C Circuit 109 (DCD) Control |
| &D Circuit 108 (DTR) Response |
| &F Set to Factory Defined Configuration |
| +GCAP Request Complete Capabilities List |
| +GMI Request Manufacturer Identification |
| +GMM Read Model Identification |
| +GMR Read Revision Identification |
| A Answer Incoming Call |
| D Dial |
| E Command Echo |
| H Hang Up |
| L Monitor Speaker Loudness |
| M Monitor Speaker Control |
| O Return to Online Data Mode |
| P Select Pulse Dialling |
| Q Result Code Suppression |
| S0 Automatic Answer Control |
| S10 Automatic Disconnect Delay Control |
| S3 Command Line Termination Character |
| S4 Response Formatting Character |
| S5 Command Line Editing Character (BACKSPACE) |
| S6 Blind Dial Delay Control |
| S7 Connection Completion Timeout |
| S8 Comma Dial Modifier Delay Control |
| T Select Tone Dialling |
| V DCE Response Format |
| X Call Progress Monitoring Control |
| Z Reset to Default Configuration |
| |
| Result codes: |
| OK Acknowledge execution of a command |
| CONNECT Connection has been established |
| RING The DCE has detected an incoming call signal from the |
| network |
| NO CARRIER The connection has been terminated, or attempt to |
| establish a connection failed |
| ERROR Error |
| NO DIALTONE No dial-tone detected |
| BUSY Busy signal detected |