imsm: rebuild from 2-disk RAID10
When RAID10 loses 2 disks and it is still operational, it cannot be
rebuilt. The rebuild process starts for the first disk and completes,
however completion is not recorded in metadata. There is an assumption
that rebuild completion corresponds to transition from degraded to
normal state. It's not the case for 2-disk RAID10 as it's still degraded
after rebuild to first disk completes.
Check if disk rebuild flag is set in the second map and clear it. So far it
has been checked only in the first map (where it was not set). The flag in
the second map has not been cleared but rebuild completion dropped second
map so the problem was not visible.
If rebuild completion is notified and array still has failed disks and is in
degraded state, check first if rebuild position is really unset (the same
check as for array in normal state). If so, mark migration as done but don't
change array state (it should remain degraded). Update failed disk number.
On rebuild start don't clear the rebuild flag in the destination map for all
the drives because failed state is lost for one of them. Just do a copy of
a map and clear the flag in the destination map for the disk that goes into
rebuild. Similarily preserve the rebuild flag in the map during disk removal.
If the disk is missing on array start and migration has been in progress,
don't just cancel it. Check first if maybe one of the disks was not under
rebuild (rebuild flag present both in source and destination map). If so,
rebuild was running despite of failed disk so there is no need to cancel
migration.
Signed-off-by: Tomasz Majchrzak <tomasz.majchrzak@intel.com>
Signed-off-by: Jes Sorensen <jsorensen@fb.com>
1 file changed
