f2fs: use helper to print zone condition
To make code clean, use blk_zone_cond_str() to print debug information.
Signed-off-by: Wu Bo <bo.wu@vivo.com>
Reviewed-by: Chao Yu <chao@kernel.org>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>
diff --git a/fs/f2fs/segment.c b/fs/f2fs/segment.c
index 2206199..5d6dae4 100644
--- a/fs/f2fs/segment.c
+++ b/fs/f2fs/segment.c
@@ -5025,17 +5025,6 @@
}
#ifdef CONFIG_BLK_DEV_ZONED
-static const char *f2fs_zone_status[BLK_ZONE_COND_OFFLINE + 1] = {
- [BLK_ZONE_COND_NOT_WP] = "NOT_WP",
- [BLK_ZONE_COND_EMPTY] = "EMPTY",
- [BLK_ZONE_COND_IMP_OPEN] = "IMPLICIT_OPEN",
- [BLK_ZONE_COND_EXP_OPEN] = "EXPLICIT_OPEN",
- [BLK_ZONE_COND_CLOSED] = "CLOSED",
- [BLK_ZONE_COND_READONLY] = "READONLY",
- [BLK_ZONE_COND_FULL] = "FULL",
- [BLK_ZONE_COND_OFFLINE] = "OFFLINE",
-};
-
static int check_zone_write_pointer(struct f2fs_sb_info *sbi,
struct f2fs_dev_info *fdev,
struct blk_zone *zone)
@@ -5066,7 +5055,7 @@
if (IS_CURSEC(sbi, GET_SEC_FROM_SEG(sbi, zone_segno))) {
f2fs_notice(sbi, "Open zones: valid block[0x%x,0x%x] cond[%s]",
zone_segno, valid_block_cnt,
- f2fs_zone_status[zone->cond]);
+ blk_zone_cond_str(zone->cond));
return 0;
}
@@ -5077,7 +5066,7 @@
if (!valid_block_cnt) {
f2fs_notice(sbi, "Zone without valid block has non-zero write "
"pointer. Reset the write pointer: cond[%s]",
- f2fs_zone_status[zone->cond]);
+ blk_zone_cond_str(zone->cond));
ret = __f2fs_issue_discard_zone(sbi, fdev->bdev, zone_block,
zone->len >> log_sectors_per_block);
if (ret)
@@ -5095,7 +5084,7 @@
*/
f2fs_notice(sbi, "Valid blocks are not aligned with write "
"pointer: valid block[0x%x,0x%x] cond[%s]",
- zone_segno, valid_block_cnt, f2fs_zone_status[zone->cond]);
+ zone_segno, valid_block_cnt, blk_zone_cond_str(zone->cond));
nofs_flags = memalloc_nofs_save();
ret = blkdev_zone_mgmt(fdev->bdev, REQ_OP_ZONE_FINISH,
