blob: baf233b3b2ca39dfd1a4b22e6984309db3d98f98 [file] [log] [blame]
;-------------------------------------------------------------------------------
;
; Copyright (c) 2013 Intel Corporation.
;
; Redistribution and use in source and binary forms, with or without
; modification, are permitted provided that the following conditions
; are met:
;
; * Redistributions of source code must retain the above copyright
; notice, this list of conditions and the following disclaimer.
; * Redistributions in binary form must reproduce the above copyright
; notice, this list of conditions and the following disclaimer in
; the documentation and/or other materials provided with the
; distribution.
; * Neither the name of Intel Corporation nor the names of its
; contributors may be used to endorse or promote products derived
; from this software without specific prior written permission.
;
; THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
; "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
; LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
; A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
; OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
; SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
; LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
; DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
; THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
; (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
; OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
;
;
; Module Name:
;
; MpFuncs.asm
;
; Abstract:
;
; This is the assembly code for Multi-processor S3 support
;
;-------------------------------------------------------------------------------
.686p
.model flat,C
.code
EXTERN InitializeFloatingPointUnits:PROC
VacantFlag Equ 00h
NotVacantFlag Equ 0ffh
LockLocation equ RendezvousFunnelProcEnd - RendezvousFunnelProcStart
StackStart equ LockLocation + 4h
StackSize equ LockLocation + 8h
RendezvousProc equ LockLocation + 0Ch
GdtrProfile equ LockLocation + 10h
IdtrProfile equ LockLocation + 16h
BufferStart equ LockLocation + 1Ch
;-------------------------------------------------------------------------------------
;RendezvousFunnelProc procedure follows. All APs execute their procedure. This
;procedure serializes all the AP processors through an Init sequence. It must be
;noted that APs arrive here very raw...ie: real mode, no stack.
;ALSO THIS PROCEDURE IS EXECUTED BY APs ONLY ON 16 BIT MODE. HENCE THIS PROC
;IS IN MACHINE CODE.
;-------------------------------------------------------------------------------------
;RendezvousFunnelProc (&WakeUpBuffer,MemAddress);
RendezvousFunnelProc PROC near C PUBLIC
RendezvousFunnelProcStart::
; At this point CS = 0x(vv00) and ip= 0x0.
db 8ch, 0c8h ; mov ax, cs
db 8eh, 0d8h ; mov ds, ax
db 8eh, 0c0h ; mov es, ax
db 8eh, 0d0h ; mov ss, ax
db 33h, 0c0h ; xor ax, ax
db 8eh, 0e0h ; mov fs, ax
db 8eh, 0e8h ; mov gs, ax
flat32Start::
db 0BEh
dw BufferStart ; mov si, BufferStart
db 66h, 8Bh, 14h ; mov edx,dword ptr [si] ; EDX is keeping the start address of wakeup buffer
db 0BEh
dw GdtrProfile ; mov si, GdtrProfile
db 66h ; db 66h
db 2Eh, 0Fh, 01h, 14h ; lgdt fword ptr cs:[si]
db 0BEh
dw IdtrProfile ; mov si, IdtrProfile
db 66h ; db 66h
db 2Eh, 0Fh, 01h, 1Ch ; lidt fword ptr cs:[si]
db 33h, 0C0h ; xor ax, ax
db 8Eh, 0D8h ; mov ds, ax
db 0Fh, 20h, 0C0h ; mov eax, cr0 ; Get control register 0
db 66h, 83h, 0C8h, 01h ; or eax, 000000001h ; Set PE bit (bit #0)
db 0Fh, 22h, 0C0h ; mov cr0, eax
FLAT32_JUMP::
db 66h, 67h, 0EAh ; far jump
dd 0h ; 32-bit offset
dw 20h ; 16-bit selector
PMODE_ENTRY:: ; protected mode entry point
mov ax, 8h
mov ds, ax
mov es, ax
mov fs, ax
mov gs, ax
mov ss, ax ; Flat mode setup.
mov esi, edx
mov edi, esi
add edi, LockLocation
mov al, NotVacantFlag
TestLock::
xchg byte ptr [edi], al
cmp al, NotVacantFlag
jz TestLock
ProgramStack::
mov edi, esi
add edi, StackSize
mov eax, dword ptr [edi]
mov edi, esi
add edi, StackStart
add eax, dword ptr [edi]
mov esp, eax
mov dword ptr [edi], eax
Releaselock::
mov al, VacantFlag
mov edi, esi
add edi, LockLocation
xchg byte ptr [edi], al
;
; Call assembly function to initialize FPU.
;
mov ebx, InitializeFloatingPointUnits
call ebx
;
; Call C Function
;
mov edi, esi
add edi, RendezvousProc
mov eax, dword ptr [edi]
test eax, eax
jz GoToSleep
call eax ; Call C function
GoToSleep::
cli
hlt
jmp $-2
RendezvousFunnelProc ENDP
RendezvousFunnelProcEnd::
;-------------------------------------------------------------------------------------
; AsmGetAddressMap (&AddressMap);
;-------------------------------------------------------------------------------------
AsmGetAddressMap PROC near C PUBLIC
pushad
mov ebp,esp
mov ebx, dword ptr [ebp+24h]
mov dword ptr [ebx], RendezvousFunnelProcStart
mov dword ptr [ebx+4h], PMODE_ENTRY - RendezvousFunnelProcStart
mov dword ptr [ebx+8h], FLAT32_JUMP - RendezvousFunnelProcStart
mov dword ptr [ebx+0ch], RendezvousFunnelProcEnd - RendezvousFunnelProcStart
popad
ret
AsmGetAddressMap ENDP
END