| // SPDX-License-Identifier: GPL-2.0 | 
 | /* | 
 |  * u-blox GNSS receiver driver | 
 |  * | 
 |  * Copyright (C) 2018 Johan Hovold <johan@kernel.org> | 
 |  */ | 
 |  | 
 | #include <linux/errno.h> | 
 | #include <linux/gnss.h> | 
 | #include <linux/gpio/consumer.h> | 
 | #include <linux/init.h> | 
 | #include <linux/kernel.h> | 
 | #include <linux/module.h> | 
 | #include <linux/of.h> | 
 | #include <linux/regulator/consumer.h> | 
 | #include <linux/serdev.h> | 
 |  | 
 | #include "serial.h" | 
 |  | 
 | struct ubx_data { | 
 | 	struct regulator *vcc; | 
 | }; | 
 |  | 
 | static int ubx_set_active(struct gnss_serial *gserial) | 
 | { | 
 | 	struct ubx_data *data = gnss_serial_get_drvdata(gserial); | 
 | 	int ret; | 
 |  | 
 | 	ret = regulator_enable(data->vcc); | 
 | 	if (ret) | 
 | 		return ret; | 
 |  | 
 | 	return 0; | 
 | } | 
 |  | 
 | static int ubx_set_standby(struct gnss_serial *gserial) | 
 | { | 
 | 	struct ubx_data *data = gnss_serial_get_drvdata(gserial); | 
 | 	int ret; | 
 |  | 
 | 	ret = regulator_disable(data->vcc); | 
 | 	if (ret) | 
 | 		return ret; | 
 |  | 
 | 	return 0; | 
 | } | 
 |  | 
 | static int ubx_set_power(struct gnss_serial *gserial, | 
 | 				enum gnss_serial_pm_state state) | 
 | { | 
 | 	switch (state) { | 
 | 	case GNSS_SERIAL_ACTIVE: | 
 | 		return ubx_set_active(gserial); | 
 | 	case GNSS_SERIAL_OFF: | 
 | 	case GNSS_SERIAL_STANDBY: | 
 | 		return ubx_set_standby(gserial); | 
 | 	} | 
 |  | 
 | 	return -EINVAL; | 
 | } | 
 |  | 
 | static const struct gnss_serial_ops ubx_gserial_ops = { | 
 | 	.set_power = ubx_set_power, | 
 | }; | 
 |  | 
 | static int ubx_probe(struct serdev_device *serdev) | 
 | { | 
 | 	struct gnss_serial *gserial; | 
 | 	struct gpio_desc *reset; | 
 | 	struct ubx_data *data; | 
 | 	int ret; | 
 |  | 
 | 	gserial = gnss_serial_allocate(serdev, sizeof(*data)); | 
 | 	if (IS_ERR(gserial)) { | 
 | 		ret = PTR_ERR(gserial); | 
 | 		return ret; | 
 | 	} | 
 |  | 
 | 	gserial->ops = &ubx_gserial_ops; | 
 |  | 
 | 	gserial->gdev->type = GNSS_TYPE_UBX; | 
 |  | 
 | 	data = gnss_serial_get_drvdata(gserial); | 
 |  | 
 | 	data->vcc = devm_regulator_get(&serdev->dev, "vcc"); | 
 | 	if (IS_ERR(data->vcc)) { | 
 | 		ret = PTR_ERR(data->vcc); | 
 | 		goto err_free_gserial; | 
 | 	} | 
 |  | 
 | 	ret = devm_regulator_get_enable_optional(&serdev->dev, "v-bckp"); | 
 | 	if (ret < 0 && ret != -ENODEV) | 
 | 		goto err_free_gserial; | 
 |  | 
 | 	/* Deassert reset */ | 
 | 	reset = devm_gpiod_get_optional(&serdev->dev, "reset", GPIOD_OUT_LOW); | 
 | 	if (IS_ERR(reset)) { | 
 | 		ret = PTR_ERR(reset); | 
 | 		goto err_free_gserial; | 
 | 	} | 
 |  | 
 | 	ret = gnss_serial_register(gserial); | 
 | 	if (ret) | 
 | 		goto err_free_gserial; | 
 |  | 
 | 	return 0; | 
 |  | 
 | err_free_gserial: | 
 | 	gnss_serial_free(gserial); | 
 |  | 
 | 	return ret; | 
 | } | 
 |  | 
 | static void ubx_remove(struct serdev_device *serdev) | 
 | { | 
 | 	struct gnss_serial *gserial = serdev_device_get_drvdata(serdev); | 
 |  | 
 | 	gnss_serial_deregister(gserial); | 
 | 	gnss_serial_free(gserial); | 
 | } | 
 |  | 
 | #ifdef CONFIG_OF | 
 | static const struct of_device_id ubx_of_match[] = { | 
 | 	{ .compatible = "u-blox,neo-6m" }, | 
 | 	{ .compatible = "u-blox,neo-8" }, | 
 | 	{ .compatible = "u-blox,neo-m8" }, | 
 | 	{}, | 
 | }; | 
 | MODULE_DEVICE_TABLE(of, ubx_of_match); | 
 | #endif | 
 |  | 
 | static struct serdev_device_driver ubx_driver = { | 
 | 	.driver	= { | 
 | 		.name		= "gnss-ubx", | 
 | 		.of_match_table	= of_match_ptr(ubx_of_match), | 
 | 		.pm		= &gnss_serial_pm_ops, | 
 | 	}, | 
 | 	.probe	= ubx_probe, | 
 | 	.remove	= ubx_remove, | 
 | }; | 
 | module_serdev_device_driver(ubx_driver); | 
 |  | 
 | MODULE_AUTHOR("Johan Hovold <johan@kernel.org>"); | 
 | MODULE_DESCRIPTION("u-blox GNSS receiver driver"); | 
 | MODULE_LICENSE("GPL v2"); |