| # SPDX-License-Identifier: GPL-2.0-only |
| menu "EEPROM support" |
| |
| config EEPROM_MAX6875 |
| tristate "Maxim MAX6874/5 power supply supervisor" |
| depends on I2C |
| help |
| If you say yes here you get read-only support for the user EEPROM of |
| the Maxim MAX6874/5 EEPROM-programmable, quad power-supply |
| sequencer/supervisor. |
| |
| All other features of this chip should be accessed via i2c-dev. |
| |
| This driver can also be built as a module. If so, the module |
| will be called max6875. |
| |
| |
| config EEPROM_93CX6 |
| tristate "EEPROM 93CX6 support" |
| help |
| This is a driver for the EEPROM chipsets 93c46 and 93c66. |
| The driver supports both read as well as write commands. |
| |
| If unsure, say N. |
| |
| config EEPROM_DIGSY_MTC_CFG |
| bool "DigsyMTC display configuration EEPROMs device" |
| depends on GPIO_MPC5200 && SPI_GPIO |
| help |
| This option enables access to display configuration EEPROMs |
| on digsy_mtc board. You have to additionally select Microwire |
| EEPROM 93XX46 driver. sysfs entries will be created for that |
| EEPROM allowing to read/write the configuration data or to |
| erase the whole EEPROM. |
| |
| If unsure, say N. |
| |
| config EEPROM_IDT_89HPESX |
| tristate "IDT 89HPESx PCIe-switches EEPROM / CSR support" |
| depends on I2C && SYSFS |
| help |
| Enable this driver to get read/write access to EEPROM / CSRs |
| over IDT PCIe-switch i2c-slave interface. |
| |
| This driver can also be built as a module. If so, the module |
| will be called idt_89hpesx. |
| |
| endmenu |
