| # |
| # Set any special options here. Most drivers will autoprobe/autoIRQ |
| # if you set the address or IRQ to zero, so we do that by default. |
| # Cards and options supported: |
| # |
| # EI_DEBUG Set the debugging level for 8390-based boards |
| # CONFIG_WD80x3 The Western Digital (SMC) WD80x3 driver |
| # WD_SHMEM=xxx Forces the address of the shared memory |
| # WD_no_mapout Don't map out the shared memory (faster, but |
| # your machine may not warm-boot). |
| # CONFIG_NE2000 The NE-[12]000 clone driver. |
| # PACKETBUF_MEMSIZE Allows an extra-large packet buffer to be |
| # used. Usually pointless under Linux. |
| # show_all_SAPROM Show the entire address PROM, not just the |
| # ethernet address, during boot. |
| # rw_bugfix Patch an obscure bug with a version of the 8390. |
| # CONFIG_HPLAN The HP-LAN driver (for 8390-based boards only). |
| # rw_bugfix Fix the same obscure bug. |
| # CONFIG_EL1 The 3c501 driver (just joking, never released) |
| # CONFIG_EL2 The 3c503 EtherLink II driver |
| # EL2_AUI Default to the AUI port instead of the BNC port |
| # no_probe_nonshared_memory Don't probe for programmed-I/O boards. |
| # EL2MEMTEST Test shared memory at boot-time. |
| # CONFIG_EL3 |
| # EL3_DEBUG Set the debugging message level. |
| # CONFIG_AT1500 |
| # LANCE_DEBUG Set the debugging message level. |
| # DEFAULT_DMA Change the default DMA to other than 5. |
| # CONFIG_PLIP The Crynwr-protocol PL/IP driver |
| # SLIP The MicroWalt SLIP driver |
| # SL_DUMP Uses the "dump frame" debug code |
| # SL_COMPRESSED Use CSLIP |
| # D_LINK The D-Link DE-600 Portable Ethernet Adaptor. |
| # D_LINK_IO The D-Link I/O address (0x378 == default) |
| # D_LINK_IRQ The D-Link IRQ number to use (IRQ7 == default) |
| # D_LINK_DEBUG Enable or disable D-Link debugging |
| # |
| |
| OPTS = #-DEI8390=0 -DEI8390_IRQ=0 |
| WD_OPTS = #-DWD_SHMEM=0 |
| EL2_OPTS = #-UEL2_AUI |
| NE_OPTS = |
| HP_OPTS = |
| PLIP_OPTS = |
| SLIP_OPTS = -DSL_DUMP -DSL_COMPRESSED |
| DL_OPTS = -DD_LINK_IO=0x378 -DD_LINK_IRQ=7 -UD_LINK_DEBUG |
| AT_OPTS = # -DLANCE_DMA=5 |
