usb: chipidea: imx: allow to configure oc polarity on i.MX25
Up to now the polarity of the over current pin was hard coded to active
high. Use the already defined device tree properties to configure polarity
on i.MX25, too. In difference to i.MX6/7 use active high behavior if the
polarity is unspecified to keep compatibility to existing device trees.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Peter Chen <peter.chen@nxp.com>
diff --git a/drivers/usb/chipidea/usbmisc_imx.c b/drivers/usb/chipidea/usbmisc_imx.c
index 4c3839d..097ffbc 100644
--- a/drivers/usb/chipidea/usbmisc_imx.c
+++ b/drivers/usb/chipidea/usbmisc_imx.c
@@ -136,6 +136,14 @@
val &= ~(MX25_OTG_SIC_MASK | MX25_OTG_PP_BIT);
val |= (MX25_EHCI_INTERFACE_DIFF_UNI & MX25_EHCI_INTERFACE_MASK) << MX25_OTG_SIC_SHIFT;
val |= (MX25_OTG_PM_BIT | MX25_OTG_OCPOL_BIT);
+
+ /*
+ * If the polarity is not configured assume active high for
+ * historical reasons.
+ */
+ if (data->oc_pol_configured && data->oc_pol_active_low)
+ val &= ~MX25_OTG_OCPOL_BIT;
+
writel(val, usbmisc->base);
break;
case 1:
@@ -145,6 +153,13 @@
val |= (MX25_H1_PM_BIT | MX25_H1_OCPOL_BIT | MX25_H1_TLL_BIT |
MX25_H1_USBTE_BIT | MX25_H1_IPPUE_DOWN_BIT);
+ /*
+ * If the polarity is not configured assume active high for
+ * historical reasons.
+ */
+ if (data->oc_pol_configured && data->oc_pol_active_low)
+ val &= ~MX25_H1_OCPOL_BIT;
+
writel(val, usbmisc->base);
break;
