| // SPDX-License-Identifier: GPL-2.0-only |
| /* |
| * FPGA Manager Driver for Efinix |
| * |
| * Copyright (C) 2025 iris-GmbH infrared & intelligent sensors |
| * |
| * Ian Dannapel <iansdannapel@gmail.com> |
| * |
| * Load Efinix FPGA firmware over SPI using the serial configuration interface. |
| * |
| * Note: Only passive mode (host initiates transfer) is currently supported. |
| */ |
| |
| #include <linux/delay.h> |
| #include <linux/fpga/fpga-mgr.h> |
| #include <linux/gpio/consumer.h> |
| #include <linux/module.h> |
| #include <linux/of.h> |
| #include <linux/spi/spi.h> |
| |
| /* |
| * 13 dummy bytes generate 104 SPI clock cycles (8 bits each). |
| * Used to meet the requirement for >100 clock cycles idle sequence. |
| */ |
| #define EFINIX_SPI_IDLE_CYCLES_BYTES 13 |
| |
| /* |
| * tDMIN: Minimum time between deassertion of CRESET_N to first |
| * valid configuration data. (32 µs) |
| */ |
| #define EFINIX_TDMIN_US_MIN 35 |
| #define EFINIX_TDMIN_US_MAX 40 |
| |
| /* |
| * tCRESET_N: Minimum CRESET_N low pulse width required to |
| * trigger re-configuration. (320 ns) |
| */ |
| #define EFINIX_TCRESETN_DELAY_MIN_US 1 |
| #define EFINIX_TCRESETN_DELAY_MAX_US 2 |
| |
| /* |
| * tUSER: Minimum configuration duration after CDONE goes high |
| * before entering user mode. (25 µs) |
| */ |
| #define EFINIX_TUSER_US_MIN 30 |
| #define EFINIX_TUSER_US_MAX 35 |
| |
| struct efinix_spi_conf { |
| struct spi_device *spi; |
| struct gpio_desc *cdone; |
| struct gpio_desc *reset; |
| }; |
| |
| static void efinix_spi_reset(struct efinix_spi_conf *conf) |
| { |
| gpiod_set_value(conf->reset, 1); |
| usleep_range(EFINIX_TCRESETN_DELAY_MIN_US, EFINIX_TCRESETN_DELAY_MAX_US); |
| gpiod_set_value(conf->reset, 0); |
| usleep_range(EFINIX_TDMIN_US_MIN, EFINIX_TDMIN_US_MAX); |
| } |
| |
| static enum fpga_mgr_states efinix_spi_state(struct fpga_manager *mgr) |
| { |
| struct efinix_spi_conf *conf = mgr->priv; |
| |
| if (conf->cdone && gpiod_get_value(conf->cdone) == 1) |
| return FPGA_MGR_STATE_OPERATING; |
| |
| return FPGA_MGR_STATE_UNKNOWN; |
| } |
| |
| static int efinix_spi_write_init(struct fpga_manager *mgr, |
| struct fpga_image_info *info, |
| const char *buf, size_t count) |
| { |
| struct efinix_spi_conf *conf = mgr->priv; |
| struct spi_transfer assert_cs = { |
| /* Keep CS asserted across configuration. */ |
| .cs_change = 1, |
| }; |
| struct spi_message message; |
| int ret; |
| |
| if (info->flags & FPGA_MGR_PARTIAL_RECONFIG) { |
| dev_err(&mgr->dev, "Partial reconfiguration not supported\n"); |
| return -EOPNOTSUPP; |
| } |
| |
| /* |
| * Efinix passive SPI configuration requires chip select to stay |
| * asserted from reset until the bitstream is fully clocked in. |
| * Lock the SPI bus so no other device can toggle CS between the |
| * reset pulse and the write/complete transfers. |
| */ |
| spi_bus_lock(conf->spi->controller); |
| spi_message_init_with_transfers(&message, &assert_cs, 1); |
| ret = spi_sync_locked(conf->spi, &message); |
| if (ret) { |
| spi_bus_unlock(conf->spi->controller); |
| return ret; |
| } |
| |
| /* Reset with CS asserted */ |
| efinix_spi_reset(conf); |
| |
| return 0; |
| } |
| |
| static int efinix_spi_write(struct fpga_manager *mgr, const char *buf, |
| size_t count) |
| { |
| struct spi_transfer write_xfer = { |
| .tx_buf = buf, |
| .len = count, |
| .cs_change = 1, |
| }; |
| struct efinix_spi_conf *conf = mgr->priv; |
| struct spi_message message; |
| int ret; |
| |
| spi_message_init_with_transfers(&message, &write_xfer, 1); |
| ret = spi_sync_locked(conf->spi, &message); |
| if (ret) { |
| dev_err(&mgr->dev, "SPI error in firmware write: %d\n", ret); |
| spi_bus_unlock(conf->spi->controller); |
| } |
| |
| return ret; |
| } |
| |
| static int efinix_spi_write_complete(struct fpga_manager *mgr, |
| struct fpga_image_info *info) |
| { |
| unsigned long timeout = |
| jiffies + usecs_to_jiffies(info->config_complete_timeout_us); |
| struct spi_transfer clk_cycles = { |
| .len = EFINIX_SPI_IDLE_CYCLES_BYTES, |
| /* Release CS after the trailing idle clocks are sent. */ |
| .cs_change = 0, |
| }; |
| struct efinix_spi_conf *conf = mgr->priv; |
| struct spi_message message; |
| int done, ret; |
| bool expired = false; |
| u8 *dummy_buf; |
| |
| dummy_buf = kzalloc(EFINIX_SPI_IDLE_CYCLES_BYTES, GFP_KERNEL); |
| if (!dummy_buf) { |
| ret = -ENOMEM; |
| goto unlock_spi; |
| } |
| |
| /* |
| * Keep the bus locked while sending the trailing idle clocks, then |
| * let this final transfer deassert CS to terminate configuration. |
| */ |
| clk_cycles.tx_buf = dummy_buf; |
| spi_message_init_with_transfers(&message, &clk_cycles, 1); |
| ret = spi_sync_locked(conf->spi, &message); |
| if (ret) { |
| dev_err(&mgr->dev, "SPI error in write complete: %d\n", ret); |
| goto free_buf; |
| } |
| |
| if (conf->cdone) { |
| while (!expired) { |
| done = gpiod_get_value(conf->cdone); |
| if (done < 0) { |
| ret = done; |
| goto free_buf; |
| } |
| if (done) |
| break; |
| |
| usleep_range(10, 20); |
| expired = time_after(jiffies, timeout); |
| } |
| |
| if (expired) { |
| dev_err(&mgr->dev, "Timeout waiting for CDONE\n"); |
| ret = -ETIMEDOUT; |
| goto free_buf; |
| } |
| } |
| |
| usleep_range(EFINIX_TUSER_US_MIN, EFINIX_TUSER_US_MAX); |
| |
| free_buf: |
| kfree(dummy_buf); |
| unlock_spi: |
| spi_bus_unlock(conf->spi->controller); |
| |
| return ret; |
| } |
| |
| static const struct fpga_manager_ops efinix_spi_ops = { |
| .state = efinix_spi_state, |
| .write_init = efinix_spi_write_init, |
| .write = efinix_spi_write, |
| .write_complete = efinix_spi_write_complete, |
| }; |
| |
| static int efinix_spi_probe(struct spi_device *spi) |
| { |
| struct efinix_spi_conf *conf; |
| struct fpga_manager *mgr; |
| |
| if (!(spi->mode & SPI_CPHA) || !(spi->mode & SPI_CPOL)) |
| return dev_err_probe(&spi->dev, -EINVAL, |
| "Unsupported SPI mode, set CPHA and CPOL\n"); |
| |
| conf = devm_kzalloc(&spi->dev, sizeof(*conf), GFP_KERNEL); |
| if (!conf) |
| return -ENOMEM; |
| |
| conf->reset = devm_gpiod_get(&spi->dev, "reset", GPIOD_OUT_HIGH); |
| if (IS_ERR(conf->reset)) |
| return dev_err_probe(&spi->dev, PTR_ERR(conf->reset), |
| "Failed to get RESET gpio\n"); |
| |
| conf->cdone = devm_gpiod_get_optional(&spi->dev, "cdone", GPIOD_IN); |
| if (IS_ERR(conf->cdone)) |
| return dev_err_probe(&spi->dev, PTR_ERR(conf->cdone), |
| "Failed to get CDONE gpio\n"); |
| |
| conf->spi = spi; |
| |
| mgr = devm_fpga_mgr_register(&spi->dev, |
| "Efinix FPGA Manager", |
| &efinix_spi_ops, conf); |
| |
| return PTR_ERR_OR_ZERO(mgr); |
| } |
| |
| static const struct of_device_id efinix_spi_of_match[] = { |
| { .compatible = "efinix,trion-config", }, |
| {} |
| }; |
| MODULE_DEVICE_TABLE(of, efinix_spi_of_match); |
| |
| static const struct spi_device_id efinix_ids[] = { |
| { "trion-config", 0 }, |
| {}, |
| }; |
| MODULE_DEVICE_TABLE(spi, efinix_ids); |
| |
| static struct spi_driver efinix_spi_driver = { |
| .driver = { |
| .name = "efinix-spi", |
| .of_match_table = efinix_spi_of_match, |
| }, |
| .probe = efinix_spi_probe, |
| .id_table = efinix_ids, |
| }; |
| |
| module_spi_driver(efinix_spi_driver); |
| |
| MODULE_LICENSE("GPL"); |
| MODULE_AUTHOR("Ian Dannapel <iansdannapel@gmail.com>"); |
| MODULE_DESCRIPTION("Efinix FPGA SPI Programming Driver"); |