|  | // SPDX-License-Identifier: GPL-2.0-or-later | 
|  | /* | 
|  | *  Copyright (C) 2015 - Ben Herrenschmidt, IBM Corp. | 
|  | * | 
|  | *  Driver for Aspeed "new" VIC as found in SoC generation 3 and later | 
|  | * | 
|  | *  Based on irq-vic.c: | 
|  | * | 
|  | *  Copyright (C) 1999 - 2003 ARM Limited | 
|  | *  Copyright (C) 2000 Deep Blue Solutions Ltd | 
|  | */ | 
|  |  | 
|  | #include <linux/export.h> | 
|  | #include <linux/init.h> | 
|  | #include <linux/list.h> | 
|  | #include <linux/io.h> | 
|  | #include <linux/irq.h> | 
|  | #include <linux/irqchip.h> | 
|  | #include <linux/irqchip/chained_irq.h> | 
|  | #include <linux/irqdomain.h> | 
|  | #include <linux/of.h> | 
|  | #include <linux/of_address.h> | 
|  | #include <linux/of_irq.h> | 
|  | #include <linux/syscore_ops.h> | 
|  | #include <linux/device.h> | 
|  | #include <linux/slab.h> | 
|  |  | 
|  | #include <asm/exception.h> | 
|  | #include <asm/irq.h> | 
|  |  | 
|  | /* These definitions correspond to the "new mapping" of the | 
|  | * register set that interleaves "high" and "low". The offsets | 
|  | * below are for the "low" register, add 4 to get to the high one | 
|  | */ | 
|  | #define AVIC_IRQ_STATUS		0x00 | 
|  | #define AVIC_FIQ_STATUS		0x08 | 
|  | #define AVIC_RAW_STATUS		0x10 | 
|  | #define AVIC_INT_SELECT		0x18 | 
|  | #define AVIC_INT_ENABLE		0x20 | 
|  | #define AVIC_INT_ENABLE_CLR	0x28 | 
|  | #define AVIC_INT_TRIGGER	0x30 | 
|  | #define AVIC_INT_TRIGGER_CLR	0x38 | 
|  | #define AVIC_INT_SENSE		0x40 | 
|  | #define AVIC_INT_DUAL_EDGE	0x48 | 
|  | #define AVIC_INT_EVENT		0x50 | 
|  | #define AVIC_EDGE_CLR		0x58 | 
|  | #define AVIC_EDGE_STATUS	0x60 | 
|  |  | 
|  | #define NUM_IRQS		64 | 
|  |  | 
|  | struct aspeed_vic { | 
|  | void __iomem		*base; | 
|  | u32			edge_sources[2]; | 
|  | struct irq_domain	*dom; | 
|  | }; | 
|  | static struct aspeed_vic *system_avic; | 
|  |  | 
|  | static void vic_init_hw(struct aspeed_vic *vic) | 
|  | { | 
|  | u32 sense; | 
|  |  | 
|  | /* Disable all interrupts */ | 
|  | writel(0xffffffff, vic->base + AVIC_INT_ENABLE_CLR); | 
|  | writel(0xffffffff, vic->base + AVIC_INT_ENABLE_CLR + 4); | 
|  |  | 
|  | /* Make sure no soft trigger is on */ | 
|  | writel(0xffffffff, vic->base + AVIC_INT_TRIGGER_CLR); | 
|  | writel(0xffffffff, vic->base + AVIC_INT_TRIGGER_CLR + 4); | 
|  |  | 
|  | /* Set everything to be IRQ */ | 
|  | writel(0, vic->base + AVIC_INT_SELECT); | 
|  | writel(0, vic->base + AVIC_INT_SELECT + 4); | 
|  |  | 
|  | /* Some interrupts have a programmable high/low level trigger | 
|  | * (4 GPIO direct inputs), for now we assume this was configured | 
|  | * by firmware. We read which ones are edge now. | 
|  | */ | 
|  | sense = readl(vic->base + AVIC_INT_SENSE); | 
|  | vic->edge_sources[0] = ~sense; | 
|  | sense = readl(vic->base + AVIC_INT_SENSE + 4); | 
|  | vic->edge_sources[1] = ~sense; | 
|  |  | 
|  | /* Clear edge detection latches */ | 
|  | writel(0xffffffff, vic->base + AVIC_EDGE_CLR); | 
|  | writel(0xffffffff, vic->base + AVIC_EDGE_CLR + 4); | 
|  | } | 
|  |  | 
|  | static void __exception_irq_entry avic_handle_irq(struct pt_regs *regs) | 
|  | { | 
|  | struct aspeed_vic *vic = system_avic; | 
|  | u32 stat, irq; | 
|  |  | 
|  | for (;;) { | 
|  | irq = 0; | 
|  | stat = readl_relaxed(vic->base + AVIC_IRQ_STATUS); | 
|  | if (!stat) { | 
|  | stat = readl_relaxed(vic->base + AVIC_IRQ_STATUS + 4); | 
|  | irq = 32; | 
|  | } | 
|  | if (stat == 0) | 
|  | break; | 
|  | irq += ffs(stat) - 1; | 
|  | generic_handle_domain_irq(vic->dom, irq); | 
|  | } | 
|  | } | 
|  |  | 
|  | static void avic_ack_irq(struct irq_data *d) | 
|  | { | 
|  | struct aspeed_vic *vic = irq_data_get_irq_chip_data(d); | 
|  | unsigned int sidx = d->hwirq >> 5; | 
|  | unsigned int sbit = 1u << (d->hwirq & 0x1f); | 
|  |  | 
|  | /* Clear edge latch for edge interrupts, nop for level */ | 
|  | if (vic->edge_sources[sidx] & sbit) | 
|  | writel(sbit, vic->base + AVIC_EDGE_CLR + sidx * 4); | 
|  | } | 
|  |  | 
|  | static void avic_mask_irq(struct irq_data *d) | 
|  | { | 
|  | struct aspeed_vic *vic = irq_data_get_irq_chip_data(d); | 
|  | unsigned int sidx = d->hwirq >> 5; | 
|  | unsigned int sbit = 1u << (d->hwirq & 0x1f); | 
|  |  | 
|  | writel(sbit, vic->base + AVIC_INT_ENABLE_CLR + sidx * 4); | 
|  | } | 
|  |  | 
|  | static void avic_unmask_irq(struct irq_data *d) | 
|  | { | 
|  | struct aspeed_vic *vic = irq_data_get_irq_chip_data(d); | 
|  | unsigned int sidx = d->hwirq >> 5; | 
|  | unsigned int sbit = 1u << (d->hwirq & 0x1f); | 
|  |  | 
|  | writel(sbit, vic->base + AVIC_INT_ENABLE + sidx * 4); | 
|  | } | 
|  |  | 
|  | /* For level irq, faster than going through a nop "ack" and mask */ | 
|  | static void avic_mask_ack_irq(struct irq_data *d) | 
|  | { | 
|  | struct aspeed_vic *vic = irq_data_get_irq_chip_data(d); | 
|  | unsigned int sidx = d->hwirq >> 5; | 
|  | unsigned int sbit = 1u << (d->hwirq & 0x1f); | 
|  |  | 
|  | /* First mask */ | 
|  | writel(sbit, vic->base + AVIC_INT_ENABLE_CLR + sidx * 4); | 
|  |  | 
|  | /* Then clear edge latch for edge interrupts */ | 
|  | if (vic->edge_sources[sidx] & sbit) | 
|  | writel(sbit, vic->base + AVIC_EDGE_CLR + sidx * 4); | 
|  | } | 
|  |  | 
|  | static struct irq_chip avic_chip = { | 
|  | .name		= "AVIC", | 
|  | .irq_ack	= avic_ack_irq, | 
|  | .irq_mask	= avic_mask_irq, | 
|  | .irq_unmask	= avic_unmask_irq, | 
|  | .irq_mask_ack	= avic_mask_ack_irq, | 
|  | }; | 
|  |  | 
|  | static int avic_map(struct irq_domain *d, unsigned int irq, | 
|  | irq_hw_number_t hwirq) | 
|  | { | 
|  | struct aspeed_vic *vic = d->host_data; | 
|  | unsigned int sidx = hwirq >> 5; | 
|  | unsigned int sbit = 1u << (hwirq & 0x1f); | 
|  |  | 
|  | /* Check if interrupt exists */ | 
|  | if (sidx > 1) | 
|  | return -EPERM; | 
|  |  | 
|  | if (vic->edge_sources[sidx] & sbit) | 
|  | irq_set_chip_and_handler(irq, &avic_chip, handle_edge_irq); | 
|  | else | 
|  | irq_set_chip_and_handler(irq, &avic_chip, handle_level_irq); | 
|  | irq_set_chip_data(irq, vic); | 
|  | irq_set_probe(irq); | 
|  | return 0; | 
|  | } | 
|  |  | 
|  | static const struct irq_domain_ops avic_dom_ops = { | 
|  | .map = avic_map, | 
|  | .xlate = irq_domain_xlate_onetwocell, | 
|  | }; | 
|  |  | 
|  | static int __init avic_of_init(struct device_node *node, | 
|  | struct device_node *parent) | 
|  | { | 
|  | void __iomem *regs; | 
|  | struct aspeed_vic *vic; | 
|  |  | 
|  | if (WARN(parent, "non-root Aspeed VIC not supported")) | 
|  | return -EINVAL; | 
|  | if (WARN(system_avic, "duplicate Aspeed VIC not supported")) | 
|  | return -EINVAL; | 
|  |  | 
|  | regs = of_iomap(node, 0); | 
|  | if (WARN_ON(!regs)) | 
|  | return -EIO; | 
|  |  | 
|  | vic = kzalloc(sizeof(struct aspeed_vic), GFP_KERNEL); | 
|  | if (WARN_ON(!vic)) { | 
|  | iounmap(regs); | 
|  | return -ENOMEM; | 
|  | } | 
|  | vic->base = regs; | 
|  |  | 
|  | /* Initialize sources, all masked */ | 
|  | vic_init_hw(vic); | 
|  |  | 
|  | /* Ready to receive interrupts */ | 
|  | system_avic = vic; | 
|  | set_handle_irq(avic_handle_irq); | 
|  |  | 
|  | /* Register our domain */ | 
|  | vic->dom = irq_domain_add_simple(node, NUM_IRQS, 0, | 
|  | &avic_dom_ops, vic); | 
|  |  | 
|  | return 0; | 
|  | } | 
|  |  | 
|  | IRQCHIP_DECLARE(ast2400_vic, "aspeed,ast2400-vic", avic_of_init); | 
|  | IRQCHIP_DECLARE(ast2500_vic, "aspeed,ast2500-vic", avic_of_init); |