| /* | |
| * OMAP hardware spinlock driver | |
| * | |
| * Copyright (C) 2010 Texas Instruments Incorporated - http://www.ti.com | |
| * | |
| * Contact: Simon Que <sque@ti.com> | |
| * Hari Kanigeri <h-kanigeri2@ti.com> | |
| * Ohad Ben-Cohen <ohad@wizery.com> | |
| * | |
| * This program is free software; you can redistribute it and/or | |
| * modify it under the terms of the GNU General Public License | |
| * version 2 as published by the Free Software Foundation. | |
| * | |
| * This program is distributed in the hope that it will be useful, but | |
| * WITHOUT ANY WARRANTY; without even the implied warranty of | |
| * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU | |
| * General Public License for more details. | |
| */ | |
| #include <linux/kernel.h> | |
| #include <linux/module.h> | |
| #include <linux/device.h> | |
| #include <linux/delay.h> | |
| #include <linux/io.h> | |
| #include <linux/bitops.h> | |
| #include <linux/pm_runtime.h> | |
| #include <linux/slab.h> | |
| #include <linux/spinlock.h> | |
| #include <linux/hwspinlock.h> | |
| #include <linux/platform_device.h> | |
| #include "hwspinlock_internal.h" | |
| /* Spinlock register offsets */ | |
| #define SYSSTATUS_OFFSET 0x0014 | |
| #define LOCK_BASE_OFFSET 0x0800 | |
| #define SPINLOCK_NUMLOCKS_BIT_OFFSET (24) | |
| /* Possible values of SPINLOCK_LOCK_REG */ | |
| #define SPINLOCK_NOTTAKEN (0) /* free */ | |
| #define SPINLOCK_TAKEN (1) /* locked */ | |
| #define to_omap_hwspinlock(lock) \ | |
| container_of(lock, struct omap_hwspinlock, lock) | |
| struct omap_hwspinlock { | |
| struct hwspinlock lock; | |
| void __iomem *addr; | |
| }; | |
| struct omap_hwspinlock_state { | |
| int num_locks; /* Total number of locks in system */ | |
| void __iomem *io_base; /* Mapped base address */ | |
| }; | |
| static int omap_hwspinlock_trylock(struct hwspinlock *lock) | |
| { | |
| struct omap_hwspinlock *omap_lock = to_omap_hwspinlock(lock); | |
| /* attempt to acquire the lock by reading its value */ | |
| return (SPINLOCK_NOTTAKEN == readl(omap_lock->addr)); | |
| } | |
| static void omap_hwspinlock_unlock(struct hwspinlock *lock) | |
| { | |
| struct omap_hwspinlock *omap_lock = to_omap_hwspinlock(lock); | |
| /* release the lock by writing 0 to it */ | |
| writel(SPINLOCK_NOTTAKEN, omap_lock->addr); | |
| } | |
| /* | |
| * relax the OMAP interconnect while spinning on it. | |
| * | |
| * The specs recommended that the retry delay time will be | |
| * just over half of the time that a requester would be | |
| * expected to hold the lock. | |
| * | |
| * The number below is taken from an hardware specs example, | |
| * obviously it is somewhat arbitrary. | |
| */ | |
| static void omap_hwspinlock_relax(struct hwspinlock *lock) | |
| { | |
| ndelay(50); | |
| } | |
| static const struct hwspinlock_ops omap_hwspinlock_ops = { | |
| .trylock = omap_hwspinlock_trylock, | |
| .unlock = omap_hwspinlock_unlock, | |
| .relax = omap_hwspinlock_relax, | |
| }; | |
| static int __devinit omap_hwspinlock_probe(struct platform_device *pdev) | |
| { | |
| struct omap_hwspinlock *omap_lock; | |
| struct omap_hwspinlock_state *state; | |
| struct hwspinlock *lock; | |
| struct resource *res; | |
| void __iomem *io_base; | |
| int i, ret; | |
| res = platform_get_resource(pdev, IORESOURCE_MEM, 0); | |
| if (!res) | |
| return -ENODEV; | |
| state = kzalloc(sizeof(*state), GFP_KERNEL); | |
| if (!state) | |
| return -ENOMEM; | |
| io_base = ioremap(res->start, resource_size(res)); | |
| if (!io_base) { | |
| ret = -ENOMEM; | |
| goto free_state; | |
| } | |
| /* Determine number of locks */ | |
| i = readl(io_base + SYSSTATUS_OFFSET); | |
| i >>= SPINLOCK_NUMLOCKS_BIT_OFFSET; | |
| /* one of the four lsb's must be set, and nothing else */ | |
| if (hweight_long(i & 0xf) != 1 || i > 8) { | |
| ret = -EINVAL; | |
| goto iounmap_base; | |
| } | |
| state->num_locks = i * 32; | |
| state->io_base = io_base; | |
| platform_set_drvdata(pdev, state); | |
| /* | |
| * runtime PM will make sure the clock of this module is | |
| * enabled iff at least one lock is requested | |
| */ | |
| pm_runtime_enable(&pdev->dev); | |
| for (i = 0; i < state->num_locks; i++) { | |
| omap_lock = kzalloc(sizeof(*omap_lock), GFP_KERNEL); | |
| if (!omap_lock) { | |
| ret = -ENOMEM; | |
| goto free_locks; | |
| } | |
| omap_lock->lock.dev = &pdev->dev; | |
| omap_lock->lock.owner = THIS_MODULE; | |
| omap_lock->lock.id = i; | |
| omap_lock->lock.ops = &omap_hwspinlock_ops; | |
| omap_lock->addr = io_base + LOCK_BASE_OFFSET + sizeof(u32) * i; | |
| ret = hwspin_lock_register(&omap_lock->lock); | |
| if (ret) { | |
| kfree(omap_lock); | |
| goto free_locks; | |
| } | |
| } | |
| return 0; | |
| free_locks: | |
| while (--i >= 0) { | |
| lock = hwspin_lock_unregister(i); | |
| /* this should't happen, but let's give our best effort */ | |
| if (!lock) { | |
| dev_err(&pdev->dev, "%s: cleanups failed\n", __func__); | |
| continue; | |
| } | |
| omap_lock = to_omap_hwspinlock(lock); | |
| kfree(omap_lock); | |
| } | |
| pm_runtime_disable(&pdev->dev); | |
| iounmap_base: | |
| iounmap(io_base); | |
| free_state: | |
| kfree(state); | |
| return ret; | |
| } | |
| static int omap_hwspinlock_remove(struct platform_device *pdev) | |
| { | |
| struct omap_hwspinlock_state *state = platform_get_drvdata(pdev); | |
| struct hwspinlock *lock; | |
| struct omap_hwspinlock *omap_lock; | |
| int i; | |
| for (i = 0; i < state->num_locks; i++) { | |
| lock = hwspin_lock_unregister(i); | |
| /* this shouldn't happen at this point. if it does, at least | |
| * don't continue with the remove */ | |
| if (!lock) { | |
| dev_err(&pdev->dev, "%s: failed on %d\n", __func__, i); | |
| return -EBUSY; | |
| } | |
| omap_lock = to_omap_hwspinlock(lock); | |
| kfree(omap_lock); | |
| } | |
| pm_runtime_disable(&pdev->dev); | |
| iounmap(state->io_base); | |
| kfree(state); | |
| return 0; | |
| } | |
| static struct platform_driver omap_hwspinlock_driver = { | |
| .probe = omap_hwspinlock_probe, | |
| .remove = omap_hwspinlock_remove, | |
| .driver = { | |
| .name = "omap_hwspinlock", | |
| }, | |
| }; | |
| static int __init omap_hwspinlock_init(void) | |
| { | |
| return platform_driver_register(&omap_hwspinlock_driver); | |
| } | |
| /* board init code might need to reserve hwspinlocks for predefined purposes */ | |
| postcore_initcall(omap_hwspinlock_init); | |
| static void __exit omap_hwspinlock_exit(void) | |
| { | |
| platform_driver_unregister(&omap_hwspinlock_driver); | |
| } | |
| module_exit(omap_hwspinlock_exit); | |
| MODULE_LICENSE("GPL v2"); | |
| MODULE_DESCRIPTION("Hardware spinlock driver for OMAP"); | |
| MODULE_AUTHOR("Simon Que <sque@ti.com>"); | |
| MODULE_AUTHOR("Hari Kanigeri <h-kanigeri2@ti.com>"); | |
| MODULE_AUTHOR("Ohad Ben-Cohen <ohad@wizery.com>"); |