| # SPDX-License-Identifier: GPL-2.0-only | |
| menu "EEPROM support" | |
| config EEPROM_MAX6875 | |
| tristate "Maxim MAX6874/5 power supply supervisor" | |
| depends on I2C | |
| help | |
| If you say yes here you get read-only support for the user EEPROM of | |
| the Maxim MAX6874/5 EEPROM-programmable, quad power-supply | |
| sequencer/supervisor. | |
| All other features of this chip should be accessed via i2c-dev. | |
| This driver can also be built as a module. If so, the module | |
| will be called max6875. | |
| config EEPROM_93CX6 | |
| tristate "EEPROM 93CX6 support" | |
| help | |
| This is a driver for the EEPROM chipsets 93c46 and 93c66. | |
| The driver supports both read as well as write commands. | |
| If unsure, say N. | |
| config EEPROM_DIGSY_MTC_CFG | |
| bool "DigsyMTC display configuration EEPROMs device" | |
| depends on GPIO_MPC5200 && SPI_GPIO | |
| help | |
| This option enables access to display configuration EEPROMs | |
| on digsy_mtc board. You have to additionally select Microwire | |
| EEPROM 93XX46 driver. sysfs entries will be created for that | |
| EEPROM allowing to read/write the configuration data or to | |
| erase the whole EEPROM. | |
| If unsure, say N. | |
| config EEPROM_IDT_89HPESX | |
| tristate "IDT 89HPESx PCIe-switches EEPROM / CSR support" | |
| depends on I2C && SYSFS | |
| help | |
| Enable this driver to get read/write access to EEPROM / CSRs | |
| over IDT PCIe-switch i2c-slave interface. | |
| This driver can also be built as a module. If so, the module | |
| will be called idt_89hpesx. | |
| endmenu |