| #ifndef __AHCI_H |
| #define __AHCI_H |
| |
| #include "block.h" // struct drive_s |
| #include "types.h" // u32 |
| |
| struct sata_cmd_fis { |
| u8 reg; |
| u8 pmp_type; |
| u8 command; |
| u8 feature; |
| |
| u8 lba_low; |
| u8 lba_mid; |
| u8 lba_high; |
| u8 device; |
| |
| u8 lba_low2; |
| u8 lba_mid2; |
| u8 lba_high2; |
| u8 feature2; |
| |
| u8 sector_count; |
| u8 sector_count2; |
| u8 res_1; |
| u8 control; |
| |
| u8 res_2[64 - 16]; |
| }; |
| |
| struct ahci_ctrl_s { |
| struct pci_device *pci_tmp; |
| u16 pci_bdf; |
| u8 irq; |
| u32 iobase; |
| u32 caps; |
| u32 ports; |
| }; |
| |
| struct ahci_cmd_s { |
| struct sata_cmd_fis fis; |
| u8 atapi[0x20]; |
| u8 res[0x20]; |
| struct { |
| u32 base; |
| u32 baseu; |
| u32 res; |
| u32 flags; |
| } prdt[]; |
| }; |
| |
| /* command list */ |
| struct ahci_list_s { |
| u32 flags; |
| u32 bytes; |
| u32 base; |
| u32 baseu; |
| u32 res[4]; |
| }; |
| |
| struct ahci_fis_s { |
| u8 dsfis[0x1c]; /* dma setup */ |
| u8 res_1[0x04]; |
| u8 psfis[0x14]; /* pio setup */ |
| u8 res_2[0x0c]; |
| u8 rfis[0x14]; /* d2h register */ |
| u8 res_3[0x04]; |
| u8 sdbfis[0x08]; /* set device bits */ |
| u8 ufis[0x40]; /* unknown */ |
| u8 res_4[0x60]; |
| }; |
| |
| struct ahci_port_s { |
| struct drive_s drive; |
| struct ahci_ctrl_s *ctrl; |
| struct ahci_list_s *list; |
| struct ahci_fis_s *fis; |
| struct ahci_cmd_s *cmd; |
| u32 pnr; |
| u32 atapi; |
| char *desc; |
| int prio; |
| }; |
| |
| void ahci_setup(void); |
| int process_ahci_op(struct disk_op_s *op); |
| int ahci_cmd_data(struct disk_op_s *op, void *cdbcmd, u16 blocksize); |
| |
| #define AHCI_IRQ_ON_SG (1 << 31) |
| #define AHCI_CMD_ATAPI (1 << 5) |
| #define AHCI_CMD_WRITE (1 << 6) |
| #define AHCI_CMD_PREFETCH (1 << 7) |
| #define AHCI_CMD_RESET (1 << 8) |
| #define AHCI_CMD_CLR_BUSY (1 << 10) |
| |
| #define RX_FIS_D2H_REG 0x40 /* offset of D2H Register FIS data */ |
| #define RX_FIS_SDB 0x58 /* offset of SDB FIS data */ |
| #define RX_FIS_UNK 0x60 /* offset of Unknown FIS data */ |
| |
| /* global controller registers */ |
| #define HOST_CAP 0x00 /* host capabilities */ |
| #define HOST_CTL 0x04 /* global host control */ |
| #define HOST_IRQ_STAT 0x08 /* interrupt status */ |
| #define HOST_PORTS_IMPL 0x0c /* bitmap of implemented ports */ |
| #define HOST_VERSION 0x10 /* AHCI spec. version compliancy */ |
| |
| /* HOST_CTL bits */ |
| #define HOST_CTL_RESET (1 << 0) /* reset controller; self-clear */ |
| #define HOST_CTL_IRQ_EN (1 << 1) /* global IRQ enable */ |
| #define HOST_CTL_AHCI_EN (1 << 31) /* AHCI enabled */ |
| |
| /* HOST_CAP bits */ |
| #define HOST_CAP_SSC (1 << 14) /* Slumber capable */ |
| #define HOST_CAP_AHCI (1 << 18) /* AHCI only */ |
| #define HOST_CAP_CLO (1 << 24) /* Command List Override support */ |
| #define HOST_CAP_SSS (1 << 27) /* Staggered Spin-up */ |
| #define HOST_CAP_NCQ (1 << 30) /* Native Command Queueing */ |
| #define HOST_CAP_64 (1 << 31) /* PCI DAC (64-bit DMA) support */ |
| |
| /* registers for each SATA port */ |
| #define PORT_LST_ADDR 0x00 /* command list DMA addr */ |
| #define PORT_LST_ADDR_HI 0x04 /* command list DMA addr hi */ |
| #define PORT_FIS_ADDR 0x08 /* FIS rx buf addr */ |
| #define PORT_FIS_ADDR_HI 0x0c /* FIS rx buf addr hi */ |
| #define PORT_IRQ_STAT 0x10 /* interrupt status */ |
| #define PORT_IRQ_MASK 0x14 /* interrupt enable/disable mask */ |
| #define PORT_CMD 0x18 /* port command */ |
| #define PORT_TFDATA 0x20 /* taskfile data */ |
| #define PORT_SIG 0x24 /* device TF signature */ |
| #define PORT_SCR_STAT 0x28 /* SATA phy register: SStatus */ |
| #define PORT_SCR_CTL 0x2c /* SATA phy register: SControl */ |
| #define PORT_SCR_ERR 0x30 /* SATA phy register: SError */ |
| #define PORT_SCR_ACT 0x34 /* SATA phy register: SActive */ |
| #define PORT_CMD_ISSUE 0x38 /* command issue */ |
| #define PORT_RESERVED 0x3c /* reserved */ |
| |
| /* PORT_IRQ_{STAT,MASK} bits */ |
| #define PORT_IRQ_COLD_PRES (1 << 31) /* cold presence detect */ |
| #define PORT_IRQ_TF_ERR (1 << 30) /* task file error */ |
| #define PORT_IRQ_HBUS_ERR (1 << 29) /* host bus fatal error */ |
| #define PORT_IRQ_HBUS_DATA_ERR (1 << 28) /* host bus data error */ |
| #define PORT_IRQ_IF_ERR (1 << 27) /* interface fatal error */ |
| #define PORT_IRQ_IF_NONFATAL (1 << 26) /* interface non-fatal error */ |
| #define PORT_IRQ_OVERFLOW (1 << 24) /* xfer exhausted available S/G */ |
| #define PORT_IRQ_BAD_PMP (1 << 23) /* incorrect port multiplier */ |
| |
| #define PORT_IRQ_PHYRDY (1 << 22) /* PhyRdy changed */ |
| #define PORT_IRQ_DEV_ILCK (1 << 7) /* device interlock */ |
| #define PORT_IRQ_CONNECT (1 << 6) /* port connect change status */ |
| #define PORT_IRQ_SG_DONE (1 << 5) /* descriptor processed */ |
| #define PORT_IRQ_UNK_FIS (1 << 4) /* unknown FIS rx'd */ |
| #define PORT_IRQ_SDB_FIS (1 << 3) /* Set Device Bits FIS rx'd */ |
| #define PORT_IRQ_DMAS_FIS (1 << 2) /* DMA Setup FIS rx'd */ |
| #define PORT_IRQ_PIOS_FIS (1 << 1) /* PIO Setup FIS rx'd */ |
| #define PORT_IRQ_D2H_REG_FIS (1 << 0) /* D2H Register FIS rx'd */ |
| |
| #define PORT_IRQ_FREEZE (PORT_IRQ_HBUS_ERR | PORT_IRQ_IF_ERR | \ |
| PORT_IRQ_CONNECT | PORT_IRQ_PHYRDY | \ |
| PORT_IRQ_UNK_FIS) |
| #define PORT_IRQ_ERROR (PORT_IRQ_FREEZE | PORT_IRQ_TF_ERR | \ |
| PORT_IRQ_HBUS_DATA_ERR) |
| #define DEF_PORT_IRQ (PORT_IRQ_ERROR | PORT_IRQ_SG_DONE | \ |
| PORT_IRQ_SDB_FIS | PORT_IRQ_DMAS_FIS | \ |
| PORT_IRQ_PIOS_FIS | PORT_IRQ_D2H_REG_FIS) |
| |
| /* PORT_CMD bits */ |
| #define PORT_CMD_ATAPI (1 << 24) /* Device is ATAPI */ |
| #define PORT_CMD_LIST_ON (1 << 15) /* cmd list DMA engine running */ |
| #define PORT_CMD_FIS_ON (1 << 14) /* FIS DMA engine running */ |
| #define PORT_CMD_FIS_RX (1 << 4) /* Enable FIS receive DMA engine */ |
| #define PORT_CMD_CLO (1 << 3) /* Command list override */ |
| #define PORT_CMD_POWER_ON (1 << 2) /* Power up device */ |
| #define PORT_CMD_SPIN_UP (1 << 1) /* Spin up device */ |
| #define PORT_CMD_START (1 << 0) /* Enable port DMA engine */ |
| |
| #define PORT_CMD_ICC_MASK (0xf << 28) /* i/f ICC state mask */ |
| #define PORT_CMD_ICC_ACTIVE (0x1 << 28) /* Put i/f in active state */ |
| #define PORT_CMD_ICC_PARTIAL (0x2 << 28) /* Put i/f in partial state */ |
| #define PORT_CMD_ICC_SLUMBER (0x6 << 28) /* Put i/f in slumber state */ |
| |
| #define PORT_IRQ_STAT_DHRS (1 << 0) /* Device to Host Register FIS */ |
| #define PORT_IRQ_STAT_PSS (1 << 1) /* PIO Setup FIS */ |
| #define PORT_IRQ_STAT_DSS (1 << 2) /* DMA Setup FIS */ |
| #define PORT_IRQ_STAT_SDBS (1 << 3) /* Set Device Bits */ |
| #define PORT_IRQ_STAT_UFS (1 << 4) /* Unknown FIS */ |
| #define PORT_IRQ_STAT_DPS (1 << 5) /* Descriptor Processed */ |
| #define PORT_IRQ_STAT_PCS (1 << 6) /* Port Connect Change Status */ |
| #define PORT_IRQ_STAT_DMPS (1 << 7) /* Device Mechanical Presence |
| Status */ |
| #define PORT_IRQ_STAT_PRCS (1 << 22) /* File Ready Status */ |
| #define PORT_IRQ_STAT_IPMS (1 << 23) /* Incorrect Port Multiplier |
| Status */ |
| #define PORT_IRQ_STAT_OFS (1 << 24) /* Overflow Status */ |
| #define PORT_IRQ_STAT_INFS (1 << 26) /* Interface Non-Fatal Error |
| Status */ |
| #define PORT_IRQ_STAT_IFS (1 << 27) /* Interface Fatal Error */ |
| #define PORT_IRQ_STAT_HBDS (1 << 28) /* Host Bus Data Error Status */ |
| #define PORT_IRQ_STAT_HBFS (1 << 29) /* Host Bus Fatal Error Status */ |
| #define PORT_IRQ_STAT_TFES (1 << 30) /* Task File Error Status */ |
| #define PORT_IRQ_STAT_CPDS (1 << 31) /* Code Port Detect Status */ |
| |
| #endif // ahci.h |
