net: dsa: lantiq_gswip: Add 200ms assert delay
The delay is especially needed by the xRX300 and xRX330 SoCs. Without
this patch, some phys are sometimes not properly detected.
The patch was tested on BT Home Hub 5A and D-Link DWR-966.
Fixes: a09d042b0862 ("net: dsa: lantiq: allow to use all GPHYs on xRX300 and xRX330")
Signed-off-by: Aleksander Jan Bajkowski <olek2@wp.pl>
Signed-off-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com>
Acked-by: Hauke Mehrtens <hauke@hauke-m.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/dsa/lantiq_gswip.c b/drivers/net/dsa/lantiq_gswip.c
index 64d6dfa..2673248 100644
--- a/drivers/net/dsa/lantiq_gswip.c
+++ b/drivers/net/dsa/lantiq_gswip.c
@@ -1885,6 +1885,12 @@
reset_control_assert(gphy_fw->reset);
+ /* The vendor BSP uses a 200ms delay after asserting the reset line.
+ * Without this some users are observing that the PHY is not coming up
+ * on the MDIO bus.
+ */
+ msleep(200);
+
ret = request_firmware(&fw, gphy_fw->fw_name, dev);
if (ret) {
dev_err(dev, "failed to load firmware: %s, error: %i\n",
